Samsung LTA150XH-L06 Datasheet

DATA SHEET
SAMSUNG
LTA150XH-L06
SA-01-142
Version 06-000
www.jxlcd.com
www.jxlcd.com
22.08.2006
The information given in this document is carefully checked and believed to be reliable. However, Distec takes no
responsibility for any failure or product damage caused by the application of this information. Please check all
connections carefully with the data sheet. Distec products are not intended for use in systems in which failures of
flatpanel displays and solutions
All specifications are subject to change without notification.
DISTEC GmbH Augsburger Str. 2 D - 82110 Germering Germany
Phone: +49 - (0)89/ 89 43 63 - 0 Fax: +49 - (0)89/ 89 43 63 - 131 E-Mail: info@distec.de Internet: www.distec.de
We support you worldwide with offices in Germany, Turkey, Great Britain and the USA. For further information contact your local distributor (see last page of this data sheet).
ISSUED DATE : 2006-08-22
PRODUCT INFORMATION
PRODUCT INFORMATION
SAMSUNG TFT--
SAMSUNG TFT
SAMSUNG TFT-LCD PRODUCT INFORMATION
MODEL : LTA150XH --
MODEL : LTA150XH
MODEL : LTA150XH - L06
www.jxlcd.com
www.jxlcd.com
Note : This is Product Information is subject to change after 3 months of issuing date.
LCD PRODUCT INFORMATION
LCD PRODUCT INFORMATION
L06
L06
Product planning Group 2
Samsung Electronics Co . , LTD.
1/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
PRODUCT INFORMATION
PRODUCT INFORMATION
Contents
General Description --------------------------------------------------------------------------------- (3)
1. Absolute Maximum Ratings ------------------------------------------------------------------- (4)
2. Optical Characteristics -------------------------------------------------------------------------- (6)
3. Electrical Characteristics ------------------------------------------------------------------------(10)
3.1 TFT LCD Module
3.2 Back Light Unit
4. Block Diagram ----------------------------------------------------------------------------------- (15)
4.1 TFT LCD Module
4.2 Back Light Unit
5. Input Terminal Pin Assignment -------------------------------------------------------------- (16)
5.1 Input Signal & Power
5.2 LVDS Interface
5.3 Back Light Unit
5.4 Input Signals, Basic Display Colors and Gray Scale of Each Color
www.jxlcd.com
www.jxlcd.com
6. Interface Timing --------------------------------------------------------------------------------- (20)
6.1 Timing Parameters (DE only mode)
6.2 Timing Diagrams of interface Signal (DE only mode)
6.3 Power ON/OFF Sequence
6.4 VDD Power Dip Condition
7. Outline Dimension ------------------------------------------------------------------------------- (25)
8. Marking & Others -------------------------------------------------------------------------------- (27)
9. General Precaution ------------------------------------------------------------------------------ (30)
9.1 Handling
9.2 Storage
9.3 Operation
9.4 Others
2/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
PRODUCT INFORMATION
General Description
Description
LTA150XH-L06 is a color active matrix liquid crystal display (LCD) that uses amorphous silicon TFT (Thin Film Transistor) as switching components. This model is composed of a TFT LCD panel, a driver circuit and a back light unit. The resolution of a 15.0“ is 1024 x 768 and this model can display up to 16.2 millions colors.
Features
• High contrast ratio, High aperture structure, High-speed response time
• TN(Twisted Nematic) mode
• XGA(1024x768 pixels) resolution
• Low power consumption
• 2 dual CCFTs (Cold Cathode Fluorescent Tube)
• DE(Data Enable) Mode
• LVDS (Low Voltage Differential Signaling) Interface with 1 pixel / clock
Applications
PRODUCT INFORMATION
TV & desktop monitors Display terminals for AV application products Monitors for industrial machine
* If the module is used to other applications besides the above, please contact SEC
in advance.
General Information
ITEM SPECIFICATION Active area 304.1(H) x228.1(V) (15.0 inch diagonal )
Driver element a-Si TFT active matrix Display colors
Number of pixel 1024 x 768 pixel Pixel arrangement RGB vertical stripe Pixel pitch 0.297(H) x 0.297(W) mm
www.jxlcd.com
www.jxlcd.com
16.2M
Normally whiteDisplay Mode
UNIT mm
NOTE
Haze 25 , Anti-glare & Hard - Coating (3H)Surface treatment
3/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
Mechanical Information
PRODUCT INFORMATION
PRODUCT INFORMATION
Max.
Horizontal (H)
Module
size
Note (1) Mechanical tolerance is ± 0.5mm unless there is a special comment.
Vertical (V)
Weight
331.6331.1
254.8254.3
332.1
255.3
13.0
1350
-
mm
w/o inverter ass’y
mm mm--Depth (D)
LCD module onlyg--
w/ Inverter assemblyg--
NoteUnitTyp.Min.Item
1. Absolute Maximum Ratings
If the condition exceeds maximum ratings, it can cause malfunction or unrecoverable damage to the device.
www.jxlcd.com
www.jxlcd.com
Storage temperature
Center of Glass surface temperature
(Operation)
Shock ( non - operating )
Vibration ( non - operating )
Note (1) Ta= 25 ± 2 °C
STG
OPR
nop
nop
NoteUnitMax.Min.SymbolItem
(1)V3.6Vss-0.3VccPower Supply Voltage
60-25T
500T
(2)
(2)
(3)G50-S (4)G1.5-V
4/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
PRODUCT INFORMATION
PRODUCT INFORMATION
(2) Temperature and relative humidity range are shown in the figure below.
a. 90 % RH Max. (Ta ≤ 39 °C) b. Maximum wet-bulb temperature at 39 °C or less. (Ta ≤ 39 °C)
c. No condensation (3) 11ms, sine wave, one time for ±X, ±Y, ±Z axis (4) 10-300 Hz, Sweep rate 10min, 30min for X,Y,Z axis
(5) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
(6) If product is used for extended time excessively or exposed to high temperatures for
extended time, there is a possibility of wide viewing angle film damage which could affect visual characteristics.
(39,90)
(39,90)
www.jxlcd.com
www.jxlcd.com
25,5)
((--25,5)
Fig. Temperature and Relative humidity range
(50,50.4)
(50,50.4)
(60,27.7)
(60,27.7)
5/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
PRODUCT INFORMATION
2. Optical Characteristics
PRODUCT INFORMATION
The optical characteristics should be measured in a dark room or equivalent.
Measuring equipment : SR-3, RD-80S (TOPCON), EZ-Contrast (Eldim)
(Ta = 25 ± 2°C, VDD=3.3V, fv= 60Hz, fDCLK=65MHz, IL = 6.5mArms)
ITEM SYMBOL CONDITION MIN. TYP. MAX. UNIT
Contrast Ratio
(Center of screen)
Response Time at Ta
Luminance of White ( Center of screen)
Color
Chromaticity
( CIE 1931 )
Rising
Falling
Red
Green
Blue
www.jxlcd.com
www.jxlcd.com
White
CR
T T
YL
R R GX
GY BX
BY
WX
WY
NOTE
300
R
F
φ = 0,
X
Y
θ = 0
Normal Viewing Angle
-
-
350
Typ.
-0.03
400
5
20
400
0.624
0.356
0.280
0.585
0.144
0.076
0.280
0.290
-
10
msec
25
cd/m
Typ.
+0.03
(1), (2), (3)
(1), (5)
2
(6), (7), (8)
Hor.
Viewing
Angle
Ver.
Brightness Uniformity
L
θ
θ R
φ H
φ L
BUNI
CR 10
60
60 50
50
-
70
70
60
65
-
-
-
-
-
25
Degrees
%
(4)
6/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
Note (1) Test Equipment Setup
The measurement should be executed in a stable, windless and dark room between
30min after lighting the back light at the given temperature for stabilization of the back light. This should be measured in the center of screen.
Single lamp current : 6.5mA Environment condition : Ta = 25 ± 2 °C
Field Photo detector
2°SR-3
Photo detector
Field
PRODUCT INFORMATION
PRODUCT INFORMATION
SR-3 : 40 RD-80S : 50
www.jxlcd.com
www.jxlcd.com
TFT - LCD Module
The center of the screen
LCD Panel
7/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
Note (2) Definition of test point
(128) (640) (1152)
ACTIVE AREA
PRODUCT INFORMATION
PRODUCT INFORMATION
B
G
=
max
8
G
5
2
L
max
min
H/10
H/2
H
Note (3) Definition of Contrast Ratio (C/R)
: Ratio of gray max (Gmax) & gray min (Gmin) at the center pointof the panel
Note (4) Definition of 9 points brightness uniformity
www.jxlcd.com
www.jxlcd.com
Buni
9
6 4
3
L/10
L/2
CR
Gmax : Luminance with all pixels white Gmin : Luminance with all pixels black
BB
(max min)
100
7
1
(77)
(384)
(691)
: test point
Bmax : Maximum brightness Bmin : Minimum brightness
Note (5) Definition of Response time : Sum of Tr, Tf
Display Data White(TFT off) Black(TFT on) White(TFT off)
Optical Instruments
Response
100%
90%
10%
0%
8/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
PRODUCT INFORMATION
PRODUCT INFORMATION
Note (6) Definition of Luminance of White : Luminance of white at center point
Note (7) Definition of Color Chromaticity (CIE 1931)
Color coordinate of Red, Green, Blue & White at center point
Note (8) Definition of Viewing Angle
: Viewing angle range (CR ≥10)
www.jxlcd.com
www.jxlcd.com
9/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
3. Electrical Characteristics
3.1 TFT LCD Module
The connector for display data & timing signal should be connected.
PRODUCT INFORMATION
PRODUCT INFORMATION
Ta = 25°C
NoteUnitMax.Typ.Min.SymbolItem
Voltage of Power Supply
Differential Input
Voltage for LVDS
Receiver Threshold
LVDS skew
LVDS
Input
Characteri
stics
Current of
Power
Supply
Vsync Frequency Hsync Frequency
Differential input
Input voltage range
(single-ended)
Common mode
Input current
(a) White
www.jxlcd.com
www.jxlcd.com
Main Frequency
Rush Current
voltage
voltage
DD
SKEW
IN
V
CM
IN
I
DD
V
H
DCLK
RUSH
0+
|VID|/2
1.2
2.4-
|V
±10I
(1)V3.63.33.0V
(2)mV+100--High
mV---100Low
(3)ps380-380t (4)mV600200|VID|
(4)V2.40V
|/2
ID
mA460400­mA480420-(b) Mosaic (6),(7) mA550470-(c) Sub Dot
Hz7560-f
kHz6048.3-f
MHz806547f
(4)V (5)
(8)A1.5--I
Note (1) The ripple voltage should be controlled under 10% of VDD.
10/32Page06-000-G-060822Doc. NoLTA150XH-L06MODEL
Loading...
+ 23 hidden pages