SAMSUNG GS17CSSS_EDC Service Manual Disassembly & Reassembly

3 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the GS17CS TFT-LCD monitors.

WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling

these components.

3-1 Disassembly

Cautions:1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use any metal instrument except provided jig to separate the cabinet.

3. R/Cover opening jig : BH81-00001A

1. Place monitor face down on cushioned table. Remove 4 screws from grip on the stand and remove the stand.

2. Remove 2 screws from the rear cover and insert the opening jig into the grooves at each side and press until it clicks.

3. Lift the rear cover and remove 1 screws from the shield.

4. Lift up the panel shield and remove 4 screws from the panel shield. (Right / Left)

5. Lift up the panel shield and carefully remove the silicon glue on the cables with a Nipper.

Caution : Lamp wire may be easily damaged. Please use caution when removing the silicon.

GS17CS 3-1

3 Disassembly and Reassembly

3-2 Reassembly

6. Remove 7 screws, 2 hexa screws from the boards and lift up the boards.

Caution : When repairing panel only, disconnect just LVDS cable, Panel-Lamp / Wire marked in circle in the picture without removing the screws on board in order to lift the board up.

7. This picture is panel.

Reassembly procedures are in the reverse order of disassembly procedures.

3-2 GS17CS