Samsung GH15DS Disassemble

3-1-1 Removing the Stand

1. Remove 4 screws in the hinge area.

2. Disconnect Power Cord and Signal Cable.

3. Pry it off the back of the monitor.

3-1-2 Main Body Disassembly

1. Remove 2 screws on the two corner of the
Rear Cover.

2. Remove Rear Cover from the Front Cover.

3. Remove 4 screws on the Shield and remove
the shield.

4. Disconnect Inverter wire, Function PCB wire
and Interface wire.
Remove 3 screws on the Main PCB and
remove 2 screws on the D sub shield.

5. Remove 3 screws on the power PCB and
remove 2 screws on the Inverter PCB.

6. Remove the Main PCB Assembly.

7. Remove 3 screws on the Function PCB from
locking area of Function knob and remove
Function PCB.

3-1-3 Standard Stand Disassembly

1. Remove 2 screws from the Stand front.

2. Remove 7 screws from the Stand Bottom.

3. Remove Stand Rear from the Stand assembly.

4. Remove 5 screws from the Stand assembly.

5. Remove the Neck front from the Stand
assembly.

6. Remove 2 screws from the Stand assembly.

7. Remove Neck Rear from the Stand assembly.

8. Remove 4 screws from the Stand assembly.

GH15DS 3-1

3 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the
GH15DS monitor.

WARNING: This monitor contains electrostatically sensitive devices. Use with caution when

handling these components.

3-1 Disassembly

Cautions:1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.

3 Disassembly and Reassembly

3-2 GH15DS

1. After confirm there is nothing

on the disk

Turn the LCD module over

and put it on a flat desk set to

the ground.

3-2 Replacement Order of Lamp Assemblies (GH15DS : Samsung Panel)

2. Push down the stopper and
slide the lamp unit.

3. Please take out the lamp

unit from the LCD
module.