POWER SOURCE
CHECK INDICATOR
(When it shows,
heating does not work)
DOOR
DISPLAY
DOOR
LATCHES
VARIABLE COOKING
POWER CONTROL DIAL
TIMER DIAL
AIR FILTER
PLATE TRAY
TIME DISPLAY
POWERLEVEL
INDICATORS
SAFETY
INTERLOCK
HOLES
DEFROST
INDICATORS
+20sec
BUTTON
CANCEL
BUTTON
START
BUTTON
CEILING
COVER
Using this InstructionBooklet
You have just purchased a SAMSUNG microwave oven. Your Owner’s
Instructions contain valuable information on cooking with your
microwave oven:
•Safety precautions
•Suitable accessories and cookware
•Useful cooking tips
At the front of the booklet you will find illustrations of the oven, and
more importantly the control panel, so that you can find the buttons
more easily.
The step-by-step reocedures use two different symbols.
☛✉
ImportantNote
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
Failure to observe the following safety precautions may result in harmful
exposure to microwave energy.
(a) Under no circumstances should any attempt be made to operate the oven with
the door open or to tamper with the safety interlocks (door latches) or to insert
anything into the safety interlock holes.
(b) Do not place any object between the oven door and front face or allow food or
cleaner residues to accumulate on sealing surfaces. Ensure that the door and
door sealing surfaces are kept clean by wiping after use first with a damp cloth
and then with a soft dry cloth.
(c) Do not operate the oven if it is damaged until it has been repaired by a
qualified microwave service technician trained by the manufacturer.
It is particularly important that the oven door closes properly and that there is
no damage to the:
(1) Door, door seals and sealing surfaces
(2) Door hinges (broken or loose)
(3) Power cable
(d) The oven should not be adjusted or repaired by anyone other than a properly
qualified microwave service technician trained by the manufacturer.
2
Safety Precautiones
Before cooking food or liquids in your microwave oven, please check
that the following safety precautions are taken.
1. DO NOT use any metallic cookware in the microwave oven:
•Metallic containers
•Dinnerware with gold or silver trimmings
•Skewers, forks, etc.
Reason:Electric arcing or sparking may occur and may damage the oven.
2. DO NOT heat:
•Airtight or vacuum-sealed bottles, jars, containers
Ex) Baby food jars
•Airtight food.
Ex) Eggs, nuts in shells, tomatoes
Reason:
Tip:
3. DO NOT operate the microwave oven when it is empty.
Reason:
Tip:
4. DO NOT cover the rear ventilation slots with cloths or paper.
Reason
6. DO NOT touch heating elements or interior oven walls.
Reason
The increase in pressure may cause them to explode.
Remove lids and pierce skins, bags, etc.
The oven walls may be damaged.
Leave a glass of water inside the oven at all times. The water will
absorb the microwaves if you accidentally set the oven going when
it is empty.
: The cloths or paper may catch fire as hot air is evacuated from the
oven.
Some dishes absorb microwaves and heat is always transferred
from the food to the dish.The dishes are therefore hot
: These walls may be hot enough to burn even after cooking has
finished, enen though they do not appear to be so. Do not allow
inflammable materials to come into contact with any interior area of
the oven. Let the oven cool down first.
.
8. Take particular care when heating liquids and baby foods.
•ALWAYS allow a standing time of at least 20 seconds after the oven has
been switched off so that the temperature can equalize.
•Stir during heating, if necessary, and ALWAYS stir after heating.
•Take care when handling the container after heating. You may burn
yourself, if the container is too hot.
•A risk of delayed eruptive boiling exists.
•To prevent delayed boiling and possible scalding, you should put a plastic
spoon or glass stick into the beverages and stir before, during and after
heating.
Reason
: During the heating of liquids the boiling point can be delayed;
this means that eruptive boiling can start after the container is
•In the event of scalding, follow these FIRST AID instructions:
*Immerse the scalded area in cold water for at least 10 minutes.
*Cover with a clean, dry dressing.
*Do not apply any creams, oils or lotions.
•NEVER fill the container to the top and choose a container that is wider at
the top than at the bottom to prevent the liquid from boiling over. Bottles
with narrow necks may also explode if overheated.
•ALWAYS check the temperature of baby food or milk before giving it to
the baby.
•NEVER heat a baby’s bottle with the teat on, as the bottle may explode if
overheated.Tenga cuidado de no estropear el cable de alimentación.
9. Be careful not to damage the power cable.
•Do not immerse the power cable or plug in water and keep the power
cableawayfromheatedsurfaces.
•Do not operate this appliance if it has a damaged power cable or plug.
10. Stand at arm’s length from the oven when opening the door.
Reason
11. Keep the inside of the oven clean.
Reason
removed from the oven. You may scald yourself.
: The hot air or steam released may cause scalding.
: Food particles or spattered oils stuck to oven walls or floor can
cause paint damage and reduce the efficiency of the oven.
GB
7. Toreducetheriskoffireintheovencavity:
•Do not store flammable materials in the oven
•Remove wire twist ties from paper or plastic bags
•Do not use your microwave oven to dry newspapers.
•If smoke is observed, keep the oven door closed and switch off or
disconnect the oven from the power supply
12. You may notice a “Clicking” sound during operation(especially when the oven
is in defrosting).
Reason
: This sound is normal when the electrical power output is changing.
13. When the microwave oven is operating without any load, the power will be cut
off automatically for safety. You can operate the oven normally after letting it
stand for over 30 minutes.
3
Safety Precautiones (continued)
InstallingYour MicrowaveOven
IMPORTANT SAFETY INSTRUCTIONS
GB
During cooking, you should look into the oven from time to time when food is
being heated or cooked in disposable containers of plastic, paper or other
combustible materials.
IMPORTANT
Young children should NEVER be allowed to use or play with the microwave
oven. Nor should they be left unattended near the microwave oven when it is in
use. Items of interest to children should not be store d or hidden just above the
oven
This microwave oven can be placed almost anywhere (kitchen work
surface or shelf, movable trolley, table).
☛For your personal safety, this appliance must be:
•Properly earthed (3-pin plug)
•Plugged into a standard 230 Volt, 50 Hz, AC earthed socket
1. Install the oven on a flat, level, stable surface. Make sure there is adequate
ventilation for your oven by leaving at least 10cm(four inches) of space
behind, on the sides of the oven and 20cm(eight inches) of above.
(For stacking see page 10.)
2. Never block the air vents as the oven may overheat and automatically switch
itself off. It will remain inoperable until it has cooled sufficiently.
3. Remove all packing materials inside the oven.
4. Plug the cable into a 3-pin, earthed socket. If the power cable of this appliance
is damaged, it must be replaced by a special cable as supplied from service
center.
☛Be sure to remove the protective film from outer case. The
protective film is on the outer case to prevent scratches. When
installing or before using, be sure to remove it.
Outdoor Use
This microwave oven is not designed for outdoor use.
You should use it indoors only.
During Air Cooling
Do not turn power off while the cooling fan is automatically air-cooling for 1min.
Recommendations
✉DO NOT install the microwave oven in hot or damp surroundings.
Example: Next to a traditional oven or radiator.
✉The power supply specifications of the oven must be respected and
any extension cable used must be of the same standard as the power
cable supplied with the oven.
✉Wipe the interior and the door seal with a damp cloth before using
your microwave oven for the first time.
4
Cooking / Reheating
Make sure the oven is plugged into a properly earthed electrical outlet
and “ON” appears in the display window.
Openthedoor(Theovenlampwillbeturnedon.).
Put the food into a suitable container, place it in the centre of the oven
and then close the door securely (The oven lamp will go off.).
1. Select the desired power level by rotating the COOKING
POWER CONTROL DIAL.
Result :
2. Set the desired heating time by rotating the TIMER DIAL.
Result :
3. Pressbutton:
Result :
The selected power level will be displayed in
the display window.
“ON” blinks and the selected time is displayed
in the display window.
The oven lamp and cooling fan will be turned
on. Heating will start.
The time on digital display will count down.
✉When all time is elapsed, the end of cycle Beep
Tone will sound 4 times and all heating will stop.
The oven lamp will go off. For 1 min, the display
shows ‘0‘ and the cooling fan will keep working in
order to cool down the interior parts.
During the time, the fan will not stop even when
you open the door. 1 min later it will stop and
“ON” appears again. Food may be removed from
oven whilst the fan is still running.
✉Whilst heating, one press onpad stops the oven. You can restart it
by pressing thepad or a second press onpad will cancel the
selected program. When it is NOT in a heating cycle, one tap on
pad cancels the selected program. You can set the power level first
and then the cooking time next, or vice versa. You can press +20sec
button one or more times in order to add the cooking time by 20
seconds.
✉When heating cycle is completed and you open the door, the oven
lamp automatically turns on and goes off 1 min later.
✉When you open the door whilst in a heating cycle, the oven stops
operating and the oven lamp automatically turns on for 1 min and
goes off 1 min later. If you leave the oven door open for more than 1
min, the oven beeps once every minute and after 5 min the power
source check indicator ‘ON’ appears in the display window.
✉When in a heating cycle, you can not change the power level or
heating time. But you can add 20 sec increments using the +20sec
pad. The dial may be rotated but this does not affect the current
operationand the display remains the same. It becomes effective next
time you set the oven manually after you finish the current heating. If
you want to change the current setting, firstly stop the heating by
using CANCEL pad and set desired power level and cooking time
again.
But when you are NOT in a heating cycle, you can change the power
level and heating time. Changed values are promptly shown in the
display.
✉The oven is designed not to work when power level is set to “0” mode
between the heating mode and the defrosting mode.
✉When you first plug in the power cord, the oven beeps once and all
the indicators show for 5 sec in the display window.
GB
4. Open the door and take the food out.
Close the door. The oven lamp will go off.
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.