
Specifications
Alignment & Adjustment
Exploded View & Parts List
Electrical Part List
PCB Diagram
Schematic Diagrams
1.
2.
3.
4.
5.
6.
COLOR TELEVISION RECEIVER
Chassis : KS9B(N)
Model : CL21K5MN6X/RCL
CL21M6MQ6X/XAP
SERVICE
Manual
COLOR TELEVISION RECEIVER CONTENTS

This Service Manual is a property of Samsung Electronics Co.,Ltd.
Any unauthorized use of Manual can be punished under applicable
International and/or domestic law.
© Samsung Electronics Co., Ltd. May. 2004
Printed in Korea
AA82-01636A
ELECTRONICS

Specifications
Samsung Electronics 1-1
1. Specifications
Broadcasting System
Broadcasting System
Tuning Range
Antenna Impedance
Intermediate Frequency
Power Consumption
NTSC
Electronic Remote Control System
VHF : CH2 ~ CH13
UHF : CH14 ~ CH69
CATV : CH1,4 ~ CH125
75 ohm Unbalanced
Video : 45.75 MHz
Sound : 41.25 MHz
Chrominance Subcarrier : 42.17MHz
AC 120V/60Hz : TX-P2030. TX-P2034, TX-P2036
AC 100V~240V/60Hz : CL-21M6MQ, CL-21K5MQ, CL-21K5MN
CL-21A11MQ

Alignment & Adjustment
Samsung Electronics 2-1
2. Alignment & Adjustment
2-1 General Alignment Instructions
1. Usually, a color TV-VCR needs only slight touch-up
adjustment upon installation. Check the basic characteristics
such as height, horizontal and vertical sync and focus.
2. Observe the picture for good black and white details.
There should be objectionable color shading;
if color shading is present, demagnetize, perform purity and
convergence adjustments described below.
3. Use the specified test equipment or its equivalent.
4. Correct impedance matching is essential.
5. Avoid overload. Excessive signal from a sweep generator
might overload the front-end of the TV.
When inserting signal markers, do not allow the marker
generator to distort test results.
6. Connect the TV only to an AC power source with voltage and
frequency as specified on the backcover nameplate.
7. Do not attempt to connect or disconnect any wires while the
TV is turned on.
Make sure that the power cord is disconnected before
replacing any parts.
8. To protect against shock hazard, use an isolation
transformer.
2-2 Automatic Degaussing
A degaussing coil is mounted around the picture tube,
so that external degaussing after moving the TV should be
unnecessary. But the receiver must be properly degaussed
upon installation.
The degaussing coil operates for about 1 second after the
power is switched ON.
If the set is moved or turned in a different direction, the power
should be OFF for at least 10 minutes.
If the chassis or parts of the cabinet become magnetized,
poor color purity will result. If this happens, use an external
degaussing coil. Slowly move the degaussing coil around the
faceplate of the picture tube and the sides and front of the
receiver. Slowly withdraw the coil to a distance of about 6 feet
before turning power OFF.
If color shading persists, perform the following Color purity and
Convergence adjustments.
2-3 High Voltage Check
1. Connect a digital voltmeter to the second anode of the
picture tube.
2. Turn on the TV. Set the Brightness and Contrast controls to
minimum (zero beam current).
3. Adjust the Brightness and contrast controls to both extremes.
Ensure that the high voltage does not exceed 27 KV under
any conditions.
Caution : There is no high voltage adjustment on this chassis. The B+ power supply should be +123V
(with full color- bar input and normal picture level).

Alignment & Adjustment
2-2 Samsung Electronics
2-4 FOCUS Adjustment
1. Iput a black and white signal.
2. Adjust the tuning control for the clearest picture.
3. Adjust the FOCUS control for well defined scanning lines in
the center area of the screen.
2-5 Factory Adjustment
2-5-1 Service Mode
1. To enter the "Service Mode", Press the remotecontrol
keys in this sequence :
- If you do not have Factory remote-control
"Power Off" → "MUTE" → "1" → "8" → "2" → "Power On"
- If you have Factory remote-control
"Power On" → "DISPLAY" → "FACTORY"
2-5-2 Factoy Mode OSD
Service
ADJUST
OPTION
CHCKSUM
RESET
T-FMTNKR-0000

Alignment & Adjustment
Samsung Electronics 2-5
2-6-3 Option
6QM6M12LC
ffO
6QM5K12LC
ffO
6QM11A12LC
ffO
6302NXT
0302NXT
4302NXT
sutatS
ffO
ffO
ffO
laitinI
oeretS
oeretS
oeretS
oeretS
oeretS
oeretS
laitinI
lanretxE
lanretxE
lanretxE
lanretxE
lanretxE
lanretxE
laitinI
ffO
ffO
ffO
ffO
ffO
ffO
laitinI
hsilgnE
nO
hsilgnE
nO
hsilgnE
nO
hsilgnE
nO
hsilgnE
nO
hsilgnE
nO
laitinI
laitinI
ffO
ffO
ffO
ffO
ffO
ffO
laitinI
ffO
nO
ffO
nO
ffO
nO
nO
nO
nO
laitinI
nO
nO
nO
laitinI
O
O
O
laitinI
ffO
ffO
ffO
ffO
O
ffO
O
ffO
O
laitinI
nawiaT&aciremA htuoS
krameR
noitpircseD
lor
t
n
oC
METI
edoM lamroN
edoM laicepS
edoM oeretS
edoM onoM
esU CI FIS
el
baliavanU
oeretS
Aelbaliav
c
eS 1
~
S
o
m 001
ffO
etuM
Voedi
eretS
oiduA
oeretS
onoM
lanretxE
onoM
FIS dn'2
WS retsaM
CI FIS oN
t
c
a
TWS
elbaliavanU
b
onoM
lanretnI
al
i
a
v
Ael
f
f
nO
O
rewoP
otuA
edoM
edoM laicepS
lamroN
tceleS egaug
elbaliavanU
ffO
oiduA
n
a
L
tratS
Aelbaliav
hsinapS
hsilgnE
nO
egaugnaL
etuM
tratS
edoM lamroN
edoM laicepS
elbaliavanU
hcnerF
ff
O
letoH
elbaliavanU
Aelbaliav
nO
edoM
Aelbaliav
ffO
n
O
neercS
eulB
adanaC ,.A.S.U
elbaliavanU
1VA
Aelbaliav
ffO
n
O
VpihC
A2VA,1V
AtnenopmoC,1V
AtnenopmoC,2VA,1VAtnenopmoC,oediV-S,2VA,1V
n
e
n
o
pm
oC
1VA
VANOITPO
+
2VA
1
V
At
AtnenopmoC+2V
AoediV-S+tenopmoC+2VffO
ylnO ledoM ymrA
elbailavanU
.hC NFA
nO
NFA