READ ALL INSTRUCTIONS BEFORE USE.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
• This appliance requires a 220-240V AC power supply.
• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
• Keep the mains cord out of reach of children and ensure that it does not hang over the edge
of the work surface. Keep the cord away from heated surfaces.
• Never leave the appliance unattended when plugged in. Switch o and unplug from the
mains socket when not in use and before putting on or taking o parts or attachments.
• Never immerse the appliance in water or other liquid, or attempt to rinse electrical parts
under a tap.
• Do not reach for an appliance that has accidentally fallen into water or other liquid. Switch
o at mains and unplug immediately.
• Avoid touching the appliance with wet or damp hands, or operating in damp conditions.
• Do not touch hot surfaces without using oven gloves
• Do not use outdoors.
• Before carrying out any cleaning or maintenance operations, always disconnect the
appliance from the mains power supply by switching it o and removing the plug from the
wall socket.
• Never pull on the mains cord or the appliance to remove the plug from the socket. Never
carry the appliance by the mains cord.
• Never operate the appliance if it has a damaged cord or plug, if it is not working properly,
if it has been dropped or damaged, or dropped into water or other liquid. Return it to the
HoMedics Service Centre for examination, repair or replacement.
• Only use this appliance for the intended use as described in these instructions.
• Do not place or store the appliance where it can fall or be pulled into water or other liquid
(for example, keep away from the sink).
• Never use any attachments unless they are recommended or sold by the manufacturer
specifically for use with this appliance.
This appliance must not be operated by means of an external timer or e
control system.
SAFETY CAUTIONS
PLEASE READ THIS SECTION CAREFULLY BEFORE USING THE APPLIANCE
• When using this appliance, the hob surface will become hot and can remain hot for
some time after use. Do not touch without oven gloves until it has been given sucient time to cool.
• Do not use the appliance near other heat sources, directly underneath a wall cupboard or in
an enclosed space. Keep away from curtains and other flammable materials.
• Always unplug the appliance and allow to cool completely before cleaning or storing.
• Never cover the appliance while in use.
• Do not attempt to move the appliance when it is hot or has a pan on it.
• Do not allow pans to overheat or boil dry.
• Never use the appliance on the floor. Do not place the appliance on carpet, vinyl, a
tablecloth or on any other similar unsuitable surface.
• Never place any object or material between the hob surface and the pan.
• Do not place any metal objects (other than suitable pans) on the hob surface. E.g cutlery,
utensils, cans, foil.
• Do not block or obstruct the fan or vented areas around the product.
• Do not use the product if the glass surface becomes cracked.
• Keep products which can be aected by magnets (e.g. bank cards, cassette tapes, radios,
televisions, mobile phones and other electronic devices) away from this product.
KNOW YOUR APPLIANCE
A hob surface
B touch controls
C cooling vent
C
A
B
INTRODUCTION TO INDUCTION COOKING
Your SALTER induction hob is made from smooth, easy to clean microcrystal glass. The heat
for cooking comes from a magnetic induction coil which directly heats the base of the pan
with great speed and eciency. Using this system, temperature adjustments can be made
very rapidly, giving you precise control over your cooking.
To be suitable for induction cooking, pans need to be made from a ferrous metal such as
cast iron or steel. Pure copper or pure aluminium pans will not be suitable unless they have
a bonded ferrous base. An easy test is to hold a magnet to the base of the pan. If the magnet
sticks to the pan, the pan will be suitable for induction cooking. For ecient heat transfer, the
base of the pan must also be flat and needs to have a diameter of at least 12cm (24cm max).
See table below:
SUITABLE COOKWARE UNSUITABLE
Base diameter between 12cm and 24cm Base diameter less than 12cm or greater than 24cm
Flat bottom Rounded or uneven bottom
Steel or cast iron (with magnetic base) Aluminium or copper (non-magnetic base)
Stainless Steel (with magnetic base) Ceramic, terracotta or glass (eg pyrex)
PREPARATION FOR USE
• Remove all packaging
• Position the hob on a firm, flat and level work surface, keeping a clear space all around it
for ventilation. Do not place directly below overhanging shelves, curtains or cupboards.
• Plug into a suitable wall socket ensuring that the mains cord will be kept safely out of the
way. The unit will beep and all LEDs will flash once and then enter standby mode, where the
display is blank.
QUICK START GUIDE
Having prepared the product for use (as described above):
• Place a suitable pan, with its contents, onto the hob surface.
• Press the power button. The display will show ‘0‘.
• Press the MANUAL (POWER) button once. The program will start to heat the pan.
• Press the orbuttons at any time to increase or decrease the power level as required
between 200W and 2200W.
• Press the power button to switch o the induction at any time. Including when in CHILD
LOCK mode.
Notes
• It is normal for the fan to keep running for a few minutes after the induction is turned o.
Allow the fan to come to a stop before switching the unit o at the mains.
• The device will enter standby mode if not operated within 2 minutes.
• If the pan you have placed on the hob is unsuitable for induction cooking (see table) then
the unit will beep repeatedly and will switch to ‘E1’ display. Use a suitable pan to continue.
USING THE PROGRAM FUNCTIONS
Your SALTER induction hob has 6 built-in program functions, as described in the table below.
These programs are designed to make the everyday cooking quicker and easier at the touch
of a button.
Select the required program by pressing the SYMBOL button until the LED lights up above the SYMBOL.
NOTE: To override the programmed power setting at any time; simply use the / buttons
to raise or lower the power as required. So, for example, if the heat is too high, press to
lower the power.
PROGRAM
FUNCTION
MANUAL1200W default setting.
BOIL1600W default setting.
FRY160oC default setting.
SOUPSemi-Automatic control
STEAMSemi-Automatic control
KEEP WARMSemi-Automatic control
SYMBOL POWER SETTINGSUGGESTED USEAVAILABLE
Touch and to adjust
output levels. 11 Power
levels from 200W-2200W.
Touch and to adjust
output levels. 11 Power
levels from 200W-2200W.
Touch and to adjust
output levels. 10 Power
levels from 60oC-240oC.
1000W (for the first 2 mins)
1800W-1200W (for 30 mins)
800W inititally
200W (for remaining time)
TIMER SETTINGS
General Use1 min to 24 hours
Bringing water to the boil
quickly and eciently for
rice, pasta etc
Rapid high heat for stir
fries, searing meat etc
Homemade soups and
casseroles etc
Steaming vegetables etc30 min
Keep food warm after
cooking until ready to
serve
1 min to 24 hours
1 min to 24 hours
4 hours
30 min
TIMER
Once cooking is underway, the timer can be set as follows:
• Press the TIMER button.
• The Hours flash. Adjust the hours setting using the +/- buttons
• Press the TIMER button.
• The Minutes flash. Adjust the minutes setting using the +/- buttons
• Press the TIMER button to start the timer
• The timer display will start to flash and then alternate with the power/temp display
• When the time is up, the unit will beep and the hob will automatically switch o.
CHILD LOCK
To activate the child lock, press and hold the CHILD LOCK button for 3 secs until the
relevant LED light comes on. When child lock is activated the control buttons will not work,
preventing any accidental operation. The exception is the power button which, for safety, can
still be used to power o. To remove the child lock, press again for another 3 secs.
SAFETY ADVICE
• Induction hobs will only heat metal objects of a certain size and type (eg saucepans!)
Therefore if you were to place just your hand on the cold hob and then switch it on, there
would be no heat transfer. Even a metal ring on your finger will not become hot as it is too
small in size. However, please note carefully the following safety advice:
• During normal use in cooking with a pan, some areas of the glass hob surface will become
hot due to heat being transferred to the glass from the base of the pan. Allow the surface to
cool completely before touching, cleaning or storing the appliance.
• Never place other objects (such as metal cooking utensils) on the hob surface with the pan
as they will heat up also.
• If a pan boils over, always switch o the power immediately, remove the plug from the
mains supply and allow everything to cool completely before cleaning up the spill.
ERROR CODES
E1
E2Overheat Protection; Switch o at the mains and allow to cool before re-use
E3Mains voltage too high
E4Mains voltage too low
E5Temperature sensor error; switch o at the mains. Contact HoMedics Service if error persists
E6Boil dry protection; switch o and check the pan has something in before restarting
Pan not suitable; Use a suitable induction pan (see suitable cookware in introduction to
cooking section, pg 3.)
CLEANING AND CARE
• Before any cleaning operation always switch o and disconnect the appliance from the
mains power supply and allow to cool completely. To keep your appliance in the best
condition; clean after every use and before storing.
• The hob must not be immersed in water. Never hold under running water.
• Wipe the external surfaces with a clean, damp cloth as required.
• Do not use harsh abrasive cleaning products or solvents.
• To avoid scratching the glass, please avoid dragging pans across the hob surface,
particularly uncoated cast iron pans which can have a rough finish.
• Never attempt to disassemble any part of the product for cleaning or any other purpose.
• Periodically, we recommended using a vacuum cleaner to remove any build up of dust
from the fan housing on the underside of the product and the cooling vent at the rear of the
product. No disassembly is required for this procedure.
TECHNICAL DATA
• Voltage: 220-240V~50Hz
• Power: 2200 Watts
• Power consumption in Standby mode: <0.5W
• Protection Classification: II
Replacing the plug
If the plug on this appliance is damaged, it can be replaced with
a BS 1363 plug, fitted with a 13A BS 1362 fuse. Only use a 13
amp fuse with this appliance.
Care must be taken when changing the plug. If in doubt,
contact a qualified electrician.
WEEE INFORMATION
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
2 YEAR GUARANTEE
This product is intended for domestic use only. Salter will repair or replace the product, or
any part of this product free of charge if within 2 years of the date of purchase, it can be
shown to have failed through defective workmanship or materials.
This guarantee covers working parts that aect the function of the appliance. It does not
cover cosmetic deterioration caused by fair wear and tear or damage caused by accident or
misuse. Opening or taking apart the appliance or its components will void the guarantee.
Claims under guarantee must be supported by proof of purchase and be returned carriage
paid to Salter. Care should be taken in packing the appliance so that it is not damaged while
in transit. This undertaking is in addition to a consumer’s statutory rights and does not aect
those rights in any way.
For UK Sales and Service contact:
Homedics Group Ltd,
Homedics House,
Somerhill Business Park,
Five Oak Green Road,
Tonbridge,
Kent,
TN11 0GP
Helpline Tel No: (01732) 360783.
HoMedics Group Ltd
PO Box 460, Tonbridge, Kent, TN9 9EW, UK
www.salterhousewares.co.uk
IB-SDAIH102BK3GB-0414-01
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.