Ryobi RY141900 User Manual

RY141900 QUICK REFERENCE GUIDE

WARNING:

This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to
the operator’s manual.

1

Install the wheels (see page 10).

2

Attach the soap tank (see page 10).

FIRST TIME ASSEMBLY

6

Install the spray wand (see page 10).

Connect the high pressure hose to the trigger

7

handle (see page 10).

STARTING THE UNIT USING DETERGENT

Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is

1

ready for operation (see page 12).

This pressure washer is not recommended for use with an extension cord. If using an extension cord, arrange a
drip loop to avoid the possibility of the tool plug getting wet (see pages 3 and 8).

USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:

Cord Length Wire Size (A.W.G.)

25 ft. 12

Pour pressure washer

1

detergent in soap tank (see
page 14).

DETERGENT

Install blue or black soap

2

nozzle (see page 13).

Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio.

WARNING! Never use bleach or solvent-based detergent.

• Will damage your pump

• Will void your warranty

• Will damage plants/shrubs

Squeeze trigger and wait

3

approx. 5 seconds for deter­gent (see page 14).

5 S

Connect injection hose to fitting on pump (see

3

page 10).

Install the handle and spray wand storage bracket

4

(see page 10).

Connect the high pressure hose to the pump (see

8

page 11).

Connect your garden hose to the pressure washer

9

(see page 11).

Press switch ON to start the motor (see page 12).

2

SWITCH

ON

50 ft. Not Allowed

100 ft. Not Allowed

NOTE: A.W.G. = American Wire Gauge

NOZZLE SELECTION GUIDE

Use the chart below to determine the correct nozzle for your job.

Turbo Nozzle

Concrete, Brick, Masonry

Siding, Gutters, House

Fencing, Deck, Patio

  

HIGH PRESSURE

(NO SOAP WHEN USING

THESE NOZZLES)

15º

 
 

LOW

PRESSURE

(FOR SOAP OR

GENTLE RINSE)

Blue or Black

Soap Nozzle

Remove high pressure hose from reel

5

(see page 10).

Completely uncoil garden hose or remove
completely from reel to prevent kinks.

Turn water faucet on fully.

Make sure there are no leaks.

With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.

3

When finished, press switch OFF to stop the motor (see page 12).

SWITCH

OFF

Lawn Equipment, Boat, RV

 Recommended Nozzle

 Use With Caution for Certain Applications

 

BEFORE STORING THE UNIT

Always add Pump Protector to the unit after each use and before storing. This will significantly im-

1

prove pump life. (See page 14.)
Pump protector is available from your local retailer. For further assistance, call customer service at

1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.

Make the most of your purchase! Go to www.ryobitools.com

and register your new tool online. For questions about operating

or maintaining your product, please call, 1-800-860-4050.

12-23-14 (REV:01)

PROTECTOR

991000318

PUMP