Page 1
RY141802 QUICK REFERENCE GUIDE
There may be
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand
operator’s manual before using this product. All page references refer to the operator’s manual.
FIRST TIME ASSEMBLY
Connect the carrying handle to the unit
1
(see page 9).
Connect the high pressure hose to the trigger
3
handle (see page 9).
Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
1
ready for operation (see page 10).
STARTING THE UNIT USING DETERGENT
residual water in the pump
due to performance testing.
Remove the spray wand. Fill soap applicator with
1
soap. Attach soap applicator to trigger handle
(see page 12).
Squeeze trigger and wait approx. 5 seconds for
2
detergent (see page 12).
5 S
Connect the spray wand to the trigger handle
2
(see page 9).
Connect the high pressure hose to the pump
4
(see page 9).
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 2 and 7).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length Wire Size (A.W.G.)
25 ft. 14
50 ft. 12
100 ft. Not Allowed
NOTE: A.W.G. = American Wire Gauge
Press switch ON to start the motor (see page 10).
2
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
Turbo Nozzle
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
15º Soap Applicator
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
5
Connect the garden hose to the pump (see page 9).
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
SWITCH
ON
3
When finished, press switch OFF to stop the motor (see page 10).
SWITCH
OFF
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Recommended Nozzle
Use With Caution for Certain Applications
BEFORE STORING THE UNIT
Always add Pump Protector to the unit after each use and before storing. This will significantly
1
improve pump life. (See page 13)
Pump protector is available from your local retailer. For further assistance, call customer service at
1-800-525-2579.
To add, follow the instructions provided by the Pump Protector manufacturer.
PUMP
PROTECTOR
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until
a steady stream of water appears.
Make the most of your purchase! Go to www.ryobitools.com
and register your new tool online. For questions about operating
or maintaining your product please call, 1-800-525-2579.
998000643
6-29-21 (REV:01)
Loading...