RPI Industries, Inc.
AIR SCREEN and SELF-SERVE
OPERATION AND SERVICE MANUAL
WARRANTY INFORMATION
For Model
OLYMPUS MILK CASE
SCAS36R-III MC
SCAS48R-III MC
SCAS60R-III MC
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
220 Route 70, Medford, NJ 08055
Phone: (609) 714-2330 |
Fax: (609) 714-2331 |
IMPORTANT: THE FOLLOWING INFORMATION SHOULD BE RETAINED FOR FUTURE REFERENCE
RPI Industries, Inc.
Congratulations, you have just purchased the finest air screen/self-serve display case available. RPI Industries, Inc. development of an exclusive humidity and temperature control system insures product shelf life and enticing displays, which leads to a better bottom line. We at RPI Industries, Inc. hope you are satisfied with your case for many years to come.
IMPORTANT |
IMPORTANT |
IMPORTANT |
Controls are pre-set at our factory. Please consult our refrigeration service department at (609) 714-2330 if setting changes are required.
ADJUSTING CONTROLS WITHOUT PRIOR AUTHORIZATION FROM
RPI INDUSTRIES MAY VOID YOUR WARRANTY
Please consult your operation and service manual for proper care of your case.
For Your Records Enter Model And Serial Number of the Product You Purchased.
Model:____________________________
Serial No.:________________________________
CASES ARE DESIGNED TO OPERATE IN AN ENVIRONMENT OF 75 DEGREES
FAHRENHEIT AMBIENT AND 55% HUMIDITY.
2
|
TABLE OF CONTENTS |
|
Page |
General Information |
4 |
Introduction |
5 |
Receiving & Inspection Procedure |
6 |
Locating The Fixture |
6 |
Installation |
7 |
Operating Instructions |
8, 9 |
Temperature Control |
8 |
Stocking the Cabinet |
8 |
Drain Evaporator Pan |
8 |
Maintenance |
9 |
Remote Models |
10, 11 |
Warranty |
12 |
Motor-Compressor Warranty |
13 |
Specifications |
14 |
Troubleshooting |
15, 16 |
3
GENERAL INFORMATION
RPI Industries, Inc. Recommends That A Qualified Refrigeration Technician perform The Installation, Inspection and Start-Up of Refrigeration Equipment.
RPI Industries, Inc. Makes No Other Expressed Or Implied Warranty, And No Person or
Representative Of The Seller Is Authorized To Add To The Seller’s Liabilities in
Connection With Its Products Other Than What Is Expressed.
Warranties Listed Here Are For Equipment Located Inside The Continental United States.
All Services Labor And/Or Part Charges Are Subject to Approval By RPI Industries, Inc. Contact the Service Department in Writing or Call (609) 714-2330, E-mail www.regalpinnacle.com.
All Claims Must Contain The Following Information:
*The model and serial number of the equipment.
*The date of the equipment failure and place of installation.
*The name and address of the agency which will perform the service work.
A complete description of the equipment failure, circumstances relating to that failure, parts replaced and itemized list of all labor charges to be incurred.
RPI Industries, Inc. Shall Not Be Liable For Any Default Or Delay In Performance Caused By Any Contingency Beyond Its Control.
Warranties Do Not Include Any Food or Business Loss and Transportation
Charges To Or From RPI Industries’ factory.
Serial Number Nomenclature: Eight Digits ( XXXXXXXX )
* |
First Two Digits = |
Month |
* |
Second Two Digits = |
Year |
* |
Last Four Digits = |
Case number |
CASES ARE DESIGNED TO OPERATE IN AN ENVIRONMENT OF 75 DEGREES FAHRENHEIT AMBIENT AND 55% HUMIDITY.
4
INTRODUCTION
REFRIGERATED AIR SCREENS and SELF SERVE CASES
OPERATION & SERVICE MANUAL
1.Temperature of case is controlled by Digital Control Cases are pre-set at factory. Settings should not be touched, without first notifying the factory.
2.Condensing unit is 115/60 or 208/230V/60 cycle/single phase air-cooled or equal.
3.Refrigerant: R134A, R404A
4.Average case temperature in Air Screens and Self-Serve cases is between 37 and 40 degrees Fahrenheit.
5.Make certain that the drain pan on refrigerated cases is checked weekly. Calcium deposits may accrue depending on area and water quality. The float on the drain pan should be cleaned weekly for proper operation.
6.Brush out or vacuum condenser (looks like a black radiator) once a month for efficient operation. (When the condenser is clogged with dirt and dust, the case looses its efficiency.
7.Do not store packages against blower (evaporator coils) so airflow is not impeded.
8.Do not block airflow inside display area over front and back grill.
9.Provide adequate airflow in and around condensing unit inlet and discharge areas.
10.Tracks and sliding door fixtures should be cleaned and lubricated periodically.
11.Check inside cooling coil housing to be certain that it is free of debris.
12.Replace any malfunctioning parts as soon as possible.
Important: Failure to comply with any of above may void warranty.
5
Loading...