Rough Country 794 User Manual

92794000

JEEP JK 2 DOOR GAS TANK SKID PLATE

Thank you for choosing Rough Country for your suspension needs.

Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.

As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur.

Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Take this
into consideration while driving. Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height
over the intended height of the Rough Country product purchased. Mixing component brands is not recommended.

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re­sponsible for any product that is altered.

If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod­ucts by calling 1-800-222-7023.

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi­cle of its unique handling characteristics.

INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.

This JK 2-door gas tank skid plate is designed to work with any 2-door JK with stock suspension, a short arm lift kit, or a
Rough Country long-arm lift kit.

PRODUCT USE INFORMATION

TORQUE SPECIFICATIONS

Tools Needed

18mm socket
5/8” socket
Jack Stands

Size Grade 5 Grade 8

5/16” 15 ft/lbs 20 ft/lbs

3/8” 30 ft/lbs 35 ft/lbs

7/16” 45 ft/lbs 60 ft/lbs

1/2” 65 ft/lbs 90 ft/lbs

9/16” 95 ft/lbs 130 ft/lbs

5/8” 135 ft/lbs 175 ft/lbs

3/4” 185 ft/lbs 280 ft/lbs

Metric (Grade) 8.8 10.9 12.9

14MM 85ft/lbs 120ft/lb. 145ft/lbs

1. Remove the 2 bolts in the front of the gas tank skid plate 18mm. See Photo 1.

2. Remove the bolt from the side of the frame 18mm. See Photo 2.

PHOTO 1

3. Remove the bolt from the inside of the of the gas tank pocket 18mm and remove the factory skid plate.

4. Raise the new Rough Country skid plate up and support with jack stands. See Photo 3. Install the 2 bolts in the front of the skid
plate and the stock bolt in the outer frame mount. See Photo 4.

PHOTO 3

PHOTO 2

PHOTO 4

5. Insert the stock bolt on the frame side of the skid plate and tighten with a 18mm socket. See Photo 5.

6. Remove the inside gas tank bolt from the jeep with a 18mm socket and install the correct mounting bracket. Hand tighten stock
bolt. See Photo 6.

PHOTO 5

PHOTO 6