92RC0400
BOOMERANG SHACKLE KIT
Thank you for choosing Rough Country for your suspension needs.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure you have all the needed parts and understand where they go.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility, that seat belts and shoulder harnesses should be worn at all times. Avoid situations where a side rollover may occur. Braking performance and capabilities are decreased when significantly larger/heaver tires and wheels are used. Take this into consideration while driving. Also, speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height of the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be responsible for any product that is altered.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling characteristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation instructions on too the vehicle owner for review and to be kept in the vehicle for its service life.
PARTS LIST
2-Assembled Shackles
1-Poly bag:
4-bolts
4-nuts
8-washers
INSTALLATION INSTRUCTIONS
1.Park vehicle on a clean, level surface and block the wheels for safety.
2.Raise the front (or rear if installing rear kit) of the vehicle.
3.Place jack stands under the frame rails and lower the axle onto the jack stands to remove pressure from shackle assemblies.
4.Remove the stock bolts that secure the stock shackle to the frame and retain stock hardware. Due to the limited clearance with the gas tank, it may be necessary to cut the stock bolt from the upper shackle mount. See Photo1.
5.Remove the stock shackles.
6.Using the floor jack lower the axle to allow for the installation of the new lifted Rough Country boomerang shackles.
PHOTO 1 |
|
PHOTO 2 |
|
|
|
REAR INSTALLATION SHOWN
Loading...