Rocky Mountain Radar Laser-Stik User Manual

LAZER STIK INSTALLATION INSTRUCTIONS

It is very important that the Laser Stik is mounted properly for optimum performance.
P l e a s e r e a d t h e s e i n s t r u c t i o n s b e f o r e s t a r t i n g y o u r i n s t a l l a t i o n .

!

Determine the best location for the Laser Stik. For
optimum performance install the Laser Stik on a flat surface
around the front area of the vehicle with a clear view
of the road.

!

Apply the supplied double sided tape to the Laser Stik on
the backside. Do not peel off both sides of tape until
ready to apply to vehicle.

!

Clean thoroughly the surface area where the Laser Stik

!

Peel off remaining side of double sided tape and apply
Laser Stik to vehicle. Make sure the cable connector is
facing down.

!

Locate a +12V source in your vehicle.

!

Route Laser Stik cable through vehicle keeping away
from moving parts and hot surfaces.

!

Connect red wire to +12V, white wire to Ground.

!

Do not drill any holes on Laser Stik.

!

Keep front lens clean.