Rocky Mountain Radar KAT-TRAXX User Manual

TRAXX
OWNER’S MANUAL
INTRODUCTION 4 FEDERAL AND LOCAL REGULATIONS 4 WHAT’S IN THE PACKAGE 5 CONTROL AND BUTTONS 6 INSTALLATION 7 HOW DOES IT WORK? 10 WHAT CAN IT MEASURE AND DETECT? 10 SET-UP 11 ACCELERATION MODE OPERATION 14 BUTTON OPERATION FOR ACCELERATION MODES 18 SAFETY ALARM MODE OPERATION 19 RADAR DETECTOR MODE OPERATION 20 TROUBLESHOOTING 23 LASER SCRAMBLER OPERATION 24 FCC INFORMATION 25 FEATURE MEMORY 25 FACTORY RESET 26 REPLACING FUSE 26 SPECIFICATIONS 27 LIMITED WARRANTY 28 SERVICE 28
CONTENTS
OWNER’S MANUAL
4
OWNER’S MANUAL
INTRODUCTION
Thank you for purchasing the TRAXX developed by KAT Inc. TRAXX is the first and unique sophisticated device in the world, which has Vehicle performance meter and Safety alarm feature with Radar & Laser detection. The TRAXX scrambles all police laser speed measurement devices and operates automatically.
We are pleased to have you as a valued customer and hope you will be delighted with your TRAXX. This manual provides all the information you need for putting the TRAXX to work for you.
Note: Always obey all local and federal laws when using this device to measure the performance of your vehicle. Use only in designated areas with care and do not take your eyes off the road when you measure acceleration. TRAXX records the results after the run. We are not responsible for any accident or injures that occur while using this device. Drive safely.
WHAT’S IN THE PACKAGE
5
OWNER’S MANUAL
WINDSHIELD BRACKET & SUCTION CUPS TRAXX
POWER CORD & FUSE
HOOK AND LOOP FASTENER TAPE
SPARE FUSE TICKET REBATE
FEDERAL AND LOCAL REGULATIONS
The FCC passed the Communications Act in 1934 to give all citizens the right to receive all types of radio transmissions. The same radio frequencies used by police radar are also used by other devices, such as automatic door openers, burglar alarms and some amateur radio equipment. Since the TRAXX is just a radio receiver tuned to a specific portion of the public radio spectrum, it is protected under this act.
Some local, state and federal regulations may prohibit the use of this detection device. Please check with authorities regarding the use of this device before operating it.
Warning: Turn OFF Laser Scrambler in states where it is prohibited.
CONTROL AND BUTTONS
a. Power on/off and Volume Control b. DC 12V Power Input Jack c. Start Button/ Backlit Button d. Down Button/ Voice on/off Button e. Mode Button f. Memory Button/ Mute Button g. Up Button/ City Button h. Display i. Front Laser Detection Lens j. Radar Antenna k. Rear Laser Detection Lens
INSTALLATION
For the best performance of acceleration features, mount TRAXX on the windshield centered between driver and passenger. TRAXX must be positioned straight across the vehicle. Do not angle the device toward the driver. The front of the device does not have to be perfectly level. This device automatically compensates for mounting angles up to 30 degrees from level.
Adjust the device on its windshield bracket until it is approximately level. It is important that the device stays in position during use. If the device moves too easily, attach suction cups firmly.
For the best performance of radar detector feature, select the proper location for the device where it has a direct view of the road. The radar antenna and laser lens are located behind the rear panel of the device. The antenna and lens should not be obstructed by metal or metallic surface and should be pointed at the horizon for accurate long range detection.
Choose a location that does not block the driver’s vision.
Mount the device in a level position.
Do not mount the device behind metal surfaces, windshield antenna, wiper blades, ornaments or mirrored glass.
Headed windshields, currently available as an option on some Ford or GM vehicles act as an impenetrable barrier to radar signals.
Do not mount the device where the driver or passenger might collide in the case of an abrupt halt.
Note: Whichever mounting method you choose, remember to place the device out of view when you leave your vehicle. This keeps the device out of sight from thieves and prevents exposure to extremely high temperatures.
7
OWNER’S MANUAL
6
OWNER’S MANUAL
Caution: On some newer model cars, a plastic safety coating has been applied to the windshield. The suction cups may leave permanent marks on the windshield once they are removed. Check your vehicle owner’s manual to see if your car has the plastic safety coating.
�Windshield Mounting
1. Attach bracket to windshield
2. Bend bracket for correct detection angle
3. Plug power cord into the device
4. Attach bracket to device
5. Plug power cord into cigarette lighter
�Dashboard Mounting
1. Peel protective paper off one side of hook-loop
2. Tape on device’s bottom
3. Peel top paper off
4. Place device on dash board
5. Plug power cord into the device and cigarette lighter
�Power and Volume Control
The TRAXX is designed to operate on most DC12V negative ground vehicle electrical system. The power cord provided with the device has a cigarette light socket plug at one end and a small connector at the other.
To turn on the TRAXX, connect power and rotate the wheel controller, located on the side of the device, until you hear it click. To turn it off, rotate the wheel controller in the opposite direction. You can control volume level with this wheel.
9
OWNER’S MANUAL
8
OWNER’S MANUAL
HOW DOES IT WORK?
The TRAXX measures the performance of your vehicle by sensing acceleration forces. It uses a three-axis accelerometer to measure acceleration. This digital three-axis accelerometer sensor tracks your vehicle’s acceleration and cornering forces. This device analyzes data and calculates corrected G-Forces for the G Meter operation, speed and distance data. The result is the most accurate.
The TRAXX provides distinct visual and voice alerts to warn you of the presence of X, K and all kinds of Ka band radar guns in the front and rear of you. This model also provides the benefit of ‘undetectability’ by alerting you to the presence of VG-2 (Radar detector-detector). The unit also scrambles all laser devices.
The TRAXX has Safety alarm mode for safe driving. You can set safety level of lateral G-force. TRAXX gives warning sound and visual blinking whenever you exceed your level setting.
WHAT CAN IT MEASURE AND DETECT?
�TRAXX can measure the followings:
1. Time to go from 0 to 60MPH (0 to 100Km)
2. Speed at the end of 1/4 mile (400m)
3. G-Force
4. Peak and Average Horsepower
�TRAXX can detect the followings:
1. X, K and Superwide Ka band radar guns
2. Laser guns (Laser speed monitoring devices)
3. VG-2 undetectability
4. Laser Scrambler
SET-UP
If this is the first time the device is powered since installation or if the orientation has changed, please move the vehicle to a level place and calibrate the three-axis accelerometer. Press Mode button to go G-FORCE mode and complete calibration by pressing START button.
To accurately measure horsepower, the correct vehicle weight and the correction factor for the vehicle must also be entered to allow a horsepower calculation. To enter set-up mode, press MEMORY button for three (3) seconds at any mode of G­FORCE / 0 TO 60/ 1/4mile except Radar Detector mode until default weight of 2000lbs shows in the display. Please enter your vehicle weight and each correction factors.
�SET-UP FOR METRIC USE
You can set up your TRAXX for US or Metric unit and calculate engine power in HP or PS (metric horsepower). When pressing ‘DOWN’ button and turn on the Power at the same time, it displays current engaged mode. Press UP/DOWN button to toggle ‘US’ or ‘METRIC’ and press ‘MEMORY’ button to select. The factory default is ‘US’. Please enter its metric calculation factor. When ‘US’ or ‘METRIC’ is changed each other, its measurement will be changed as follows.
- US: Time to go from 0 to 60MPH / METRIC: 0 to 100Km
- US: Speed at the end of 1/4 mile / METRIC: 400m
11
OWNER’S MANUAL
10
OWNER’S MANUAL
SET-UP ITEM MIN MAX DEFAULT STEP
VEHICLE WEIGHT (LBS) 25 16000 2000 5
HP FACTOR 1.00 2.00 1.00 0.01
HP MIN SPEED (MPH) 10 60 30 1
HP MAX SPEED (MPH) 30 100 50 1
Loading...
+ 11 hidden pages