Cable Operated Disconnect Pin Replacement Kit
1494C-JK1 - (30A - 200A):1494C-CM1 thru CM8 / CMX1 thru CMX8
(400A):1494C-CM9 thru CM12 / CMX9 thru CMX12
1494C-JK2
(600A):1494C-CM13 thru CM16 / CMX13 thru CMX16
Remove defeater bracket
1
Install new pin
5
and washer
WARNING
6
6
To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep
free from contaminants.
Install new
retaining ring
Remove handle and mechanism bracket
2
Install handle and mechanism bracket
7
Remove and discard
3
retaining ring
Install defeater bracket
8
Remove and
4
discard old pin
and washer
ATTENTION: CHECK FOR PROPER OPERATION . Upon completion of the
pin replacement, if further adjustments are needed see instruction sheet(s)*
included with the pin replacement kit.
* 30A - 200A use 42052-151-01
* 400A use 42052-159-01
* 600A use 42052-191-01
During pin replacement, make sure both handle and disconnect switch are
either in the “ON” position or “OFF” position for ease of installation.
PN-81093
DIR 10000119196 (Version 00)
Printed in Mexico
30 - 40 lb-in
(30A - 200A)
60 - 80 lb-in
(400A - 600A)
7-11 lb-in