Rockwell Automation 140G-N-RMB User Manual

Page 1
140G-N-RMB, 140G-N-RMY
Direct operating mechanism for 140G-N Comando a maniglia rotante diretto Drehhebelantrieb direkt Commande par poignèe rotative directe Mando giratorio directo
Installation - Installazione - Instalación Instalação - -
WARNING:
installing or servicing. Install in suitable enclosure. Keep free from contaminants. (Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti. (Seguire i requisiti NFPA70E).
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT:
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée. Protéger le produit contre les environnements agressifs. (Vous devez respecter la norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada. Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de contaminantes. (Cumpra as exigências da norma NFPA70E).
To prevent electrical shock, disconnect from power source before
Vor Installations- oder Servicearbeiten Stromversorgung zur
Avant le montage et la mise en service, couper l'alimentation
1
Bul. 140G
2
CLACK
1
2
DIR 1000529R0611 (L4840)
Page 2
3
9.73 lb-in
1.1 Nm
4 5
1
DIR 1000529R0611 (L4840)
2
APPLY LABEL
(2)
Page 3
6
7
1
maximum n° 3 Ø 5 - 7 mm
3 maximum " to 0.2 0.27" dia.
WITH FLANGE
CON MOSTRINA
A B C
DIR 1000529R0611 (L4840)
7.91” 201 mm)
4.56” (116 mm)
0.95” (24,25 mm)
8.85 lb-in 1 Nm
A
Y
C
WITHOUT FLANGE
SENZA MOSTRINA
(
7.67” (192 mm)
4.21” (107 mm)
0.77” (19,75 mm)
B
14
(0.55")
Ø 4
(Ø 0.16”)
22.5
(0.88")
Y
R min = 200
(7.87")
(3)
Page 4
8
ok
NO!!
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication 140G-IN053A-MU-P - April 2013
DIR 1000529R0611 (L4840)
Copyright © 2013 Rockwell Automation, Inc. All Rights Reserved.
Loading...