Rocktron VFS2 User Manual

VFS2

FOOTSWITCH

Congratulations and thank you for yourpurcahse of the Rocktron VFS2 Dual Footswitch. Although the VFS2
has many uses, it is mainly used to switch channels and turn effects on/off on your guitar amplifier

USE A STEREO

1/4” CABLE

The LED ON/OFF status changes each time you
press a switch. Press a switch once, it is ON and the
LED will lite. Press the switch once more and it
will turn OFF and the LED will go out.

THE LED indication light provides confirmation
“at-a-glance” that the switch is either ON or OFF.
A 9-Volt Battery powers the LED’s and is
accessable through the battery compartment
located on the bottom of the VFS2.

ON/OFF LEDS

a

b

Use a STEREO 1/4” cable to make the connection
from the pedal to the footswitch jack on your
amplifier or rack unit.

Use the VFS2 to change channels on your
amplifier and turn ON/OFF effects (such as chorus
or reverb).

USE A STEREO

1/4” CABLE

Guitar

Output

Footswitch Jack
on back of amp

clean

effect

TM

reverb

channelchannel
selectselect

dist.

max

active

POWER

headphone

TM

NOISE REDUCTION

12ax7 TUBE PREAMP with

AGX

Input

DISTORTION

V160R

Amp

TREBLEBASS middle GAINlevel TREBLEBASS middle level

input

AGX

threshold

min

Footswitch

Jack

VFS2

SWITCHES. PRESS TO TURN

ON/OFF. WHEN ON LED

WILL BE “LIT”. WHEN OFF

USE A STEREO

1/4” CABLE

FOOTSWITCH

FOOTSWITCH ON/OFF

LED WILL NOT BE LIT.

VFS2

a

b

FOOTSWITCH