Roberts Radio R9968 User Manual

Download

R9968

Analogue World Radio

ROBERTS

Sound for Generations

Please read this manual before use

Contents

Contents..............................................................................2

Controls ........................................................................... 3-6

Batteries..............................................................................7

Disabling the buttons.........................................................8

Switching on and setting the time zone ............................ 8

Setting the local time ......................................................... 9

Setting Summer Time ........................................................9

Switching between local time and GMT .......................... 10

Shortwave radio reception ................................................ 10

Listening to the radio ........................................................ 11

Setting the alarm time......................................................12

Setting the alarm to buzzer ............................................. 13

Setting the alarm to radio ................................................ 14

Checking the alarm time..................................................15

Snooze control..................................................................15

Sleep timer........................................................................16

Backlight ...........................................................................16

Reset .................................................................................17

Headphones ......................................................................17

Stereo/Mono reception .....................................................17

Specifications ...................................................................18

Guarantee..........................................................................19

OVERVIEW Controls - Front

1345

1213

7 8

1. Display

2. Time Set

3. Alarm Set

4. 12/24 Hour

5. H/W Summer

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

6. On/Off Sleep

7. Alarm

8. Hour Set

9. Minute Set

10. H.T.Z.

11. Time Zone Dial

12. Summer Time

13. Lock

Controls Right side

Left side

14. Tuning dial

15. Mono/Stereo switch

16. Volume control

17. Headphones socket

18. DC 3-6V Power Input socket

Controls Top 20

19. Telescopic aerial

20. Band selection switch

21. Snooze & light button

Bottom

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

22. Battery compartment

23. Reset button

Controls Back

24. Map of World Time Zones

25. Frequency Scale

Batteries

1. Batteries should be replaced when the Battery Level icon shows low.

2. Press the On/Off Sleep button to switch the radio off before replacing the batteries.

3. Open the battery cover located on the underside of your receiver by pressing down and lifting the battery cover.

4. Insert 2 x AA batteries into the compartment. Make sure that the (+) and (-) ends of the batteries are positioned as shown on the rear of the receiver.

Note: 2 beep sounds will be heard to signify correct battery insertion.

5. Close the battery cover.

6. Press the On/Off Sleep button to switch the receiver on after the batteries have been replaced.

7. If the receiver is not to be used for an extended period of time it is recommended that the batteries are removed from the receiver.

8. When the power is too low for the receiver to operate the Battery Level icon

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

will flash and the unit will shut down automatically.

Disabling the buttons

The Lock button is used to prevent unintentional operation of your receiver.

1. Press the Lock button to disable the buttons on the receiver. The Key icon accidental operation when your receiver is packed in a suitcase or travel bag.

This does not affect the Volume control, the Stereo/Mono switch or the Waveband switch.

2. To enable the receiver buttons, press the Lock button again, this will cause the Key icon

will be shown in the top display panel. This will prevent

to be extinguished from the top display panel.

Switching on and setting the time zone

1. Place the unit on a flat surface. Make sure that the batteries have been inserted correctly, or if using mains power, plug the mains lead into a wall socket and switch on at the wall socket. The unit will beep twice.

2. The display will flash the Home icon current time zone.

3. Rotate the Zone control to select the city in your time zone. This will change the time zone code displayed on the top screen. The time zone codes are displayed with a world map on the rear of the unit.

4. Press the H.T.Z. button to confirm the time zone.

5. The display on the top screen will show the World icon

and the number of the

Setting the local time

1. After setting the time zone the bottom screen will flash the default time setting, 12:00 and the Home icon . If you want to change the local time later, press and hold the Time Set button until the time flashes in the bottom display.

2. Press the Hour button to change the hour.

3. Press the Min. button to change the minutes.

4. Press the 12/24 button to switch between 12 and 24 hour clock formats. When the clock is set to 12 hour display an AM or PM indicator will be displayed. Make sure that the correct 12 hour cycle is selected.

5. Press the Time Set button to confirm the correct time.

6. The bottom display will stop flashing.

Setting summer time

1. Press and hold the Time Set button until the time flashes in the bottom display.

2. Press the H/W Summer button to put the clock forward by one hour. The Summer time icon

3. Press the H/W Summer button again to remove the Summer Time icon

and return the time to its original setting.

will appear in the display.

4. Press the Time Set button to confirm the change.

5. The bottom display will stop flashing.

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

Switching between local time and GMT

1. Press the H/W Summer button to switch between local time and GMT.

2. The displays will swap over the time settings.

3. Press the H/W Summer button again to return the displays.

Short wave radio reception

Your World Receiver can receive signals in a number of wavebands. FM and MW stations are always set at the same position on the tuning scale because they are broadcast at fixed wavelengths and frequencies.

Due to atmospheric conditions, short wave stations must frequently be broadcast on different wavelengths. Most short wave bands are available all over the world and can be used by international broadcasters. At present these are the only wavelengths which provide listeners with direct reception over long distances. For this reason, short wave frequencies are not only used by radio stations, but also by other users such as amateur radio enthusiasts, shipping, aircraft and radio navigation systems.

If you want to listen to a particular SW station, you need to know the precise frequency and wavelength. Many short wave stations will send you broadcasting schedules which give you the information you need. You can also download the information from the Internet.

Listening to the radio

1. Switch on your receiver by pressing the ON/OFF Sleep button.

2. The receiver will automatically tune in to the last radio station selected.

3. The radio frequency and waveband information will show in the top display.

4. Slide the Waveband switch to the required waveband. The selected band is indicated in the top display.

5. Tune in to the desired station by rotating the Tuning control. The station frequency is shown in the top display.

6. When the radio is tuned in correctly to a station, the Tuning icon will appear in the top display.

The Telescopic antenna located on the top of your receiver is for FM and short wave (SW) reception.

Extend and tilt the Telescopic antenna to obtain the best reception for FM stations.

For short wave (SW) reception, adjust the Telescopic antenna to an upright position.

For MW reception there is a built in ferrite aerial. Rotate the receiver to the position giving the best reception.

7. Adjust the volume by rotating the Volume control.

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

Setting the alarm time

The alarm is always set in local time, with the Home icon displayed.

1. Press the Alarm button. The Alarm icon will flash in the display for a few seconds before returning to the clock display.

2. While the Alarm icon again to select the buzzer alarm mode. The Buzzer icon will appear and flash in the display.

3. Press and hold the Alarm Set button until the alarm time flashes in the display.

4. Press the Hour button to change the hour.

5. Press the Min. button to change the minutes.

6. Press the Alarm Set button to confirm the correct time.

7. The bottom display will stop flashing and the Alarm icon remain on the display.

8. Press the 12/24 button to switch between 12 and 24 hour clock formats. When the clock is set to 12 hour display an AM or PM indicator will display. Make sure that the correct 12 hour cycle is selected.

is flashing, press the Alarm button

will

Setting the alarm to buzzer

1. Set the alarm time as previously described.

2. Press the Alarm button. The Alarm icon will flash in the display for a few seconds before returning to the clock display.

3. While the Alarm icon is flashing, press the Alarm button again to select the buzzer alarm mode. The Buzzer icon will appear and flash in the display.

4. Press the Alarm Set button to confirm the alarm.

5. The bottom display will stop flashing, the Alarm icon and the Buzzer icon

6. The buzzer alarm will sound at the preset time. It will increase in volume, tone and frequency, over the period of one minute, and then fall silent for one minute. This cycle will be repeated for 60 minutes.

7. To switch off the alarm until the next day, press the On/Off Sleep button.

8. To switch the alarm off permanently, press the Alarm button. The Alarm icon reverting to the clock display.

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

will remain on the display.

will flash in the display for a few seconds before

Setting the alarm to radio

1. Set the alarm time as previously described.

2. Press the On/Off Sleep button to turn the radio on.

3. Select the required waveband using the Waveband switch and make sure that a station is tuned in.

4. Set the Volume control to the desired level.

5. Press the Alarm button. The Alarm icon display for a few seconds before returning to the clock display.

6. While the Alarm icon is flashing, press the Alarm button twice to select the radio alarm mode. The Radio icon will appear and flash in the display.

7. Press the Alarm Set button to confirm the alarm.

8. The bottom display will stop flashing, the Alarm icon Radio icon will remain on the display.

9. Press the On/Off Sleep button to turn the radio off.

10. The radio alarm will sound at the preset time for 60 minutes.

11. To switch off the alarm until the next day press the On/Off Sleep button.

12. To switch the alarm off permanently, press the Alarm button. The Alarm icon will flash in the display for a few seconds before reverting to the clock display.

will flash in the

and the

Checking the alarm time

1. Press the Alarm Set button.

2. The alarm time will appear in the bottom display for a few seconds, before reverting to the clock display.

Snooze control

1. The buzzer or radio alarm can be silenced for five minutes by pressing the Snooze Light button. This sequence can be repeated during the 60 minute alarm period.

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

Sleep timer

1. Radio playback can be set to switch off automatically after a preset time has elapsed.

2. Press the On/Off Sleep button to switch the radio on.

3. To set the Sleep Timer press and hold the On/Off Sleep button. After a few seconds the first sleep time and the Sleep icon will

appear on the top display. The display will then show the available sleep times in sequence, 60, 45, 30, 15, and 90 minutes, this will continue while the On/Off Sleep button is held. To select your preferred sleep time, release the On/Off Sleep button when the time is displayed. The display will revert to clock display after a few seconds with the sleep icon shown.

4. The radio will switch off after the selected sleep time has elapsed.

5. To cancel the sleep function before the preset time has expired, press the On/Off Sleep button.

Backlight

The Backlight illuminates the display screens, making it easy to view in a dark environment.

1. Press the Snooze Light button to switch on the Backlight for 12 seconds.

2. Press the Snooze Light button to switch the Backlight off.

Reset

The Reset function will erase all settings and return the receiver to its original state.

1. Press the Reset button on the underside of the receiver using an implement such as a paperclip.

Headphones

A 3.5 mm Headphone Socket located on the left side of the unit is provided for use with either headphones or an earpiece. Inserting a plug into the socket automatically mutes the internal loudspeaker.

Stereo/Mono reception (headphone use only)

If the FM station reception is weak it can be improved by switching to mono reception. This only works when listening to the receiver with headphones.

1. Slide the Stereo/Mono switch to the mono position. The Stereo Headphone icon disappears from the display.

2. Slide the Stereo/Mono switch back to the stereo position to return to stereo listening. The Stereo Headphone icon will show in the display.

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

Specifications

Power Requirements

Adapter Output DC 3-6 volts, 200mA

Battery 2 x LR6 (AA Size) alkaline

Frequency Coverage

FM 87.5 - 108MHz

MW 526 - 1710kHz

SW 1 - 7 5.90 - 6.20MHz (49 m)

7.10 - 7.35MHz (41 m)

9.40 - 9.90MHz (31 m)

11.6 - 12.10MHz (25 m)

13.57 - 13.87MHz (21 m)

15.1 - 15.73MHz (19 m)

17.48 - 17.9MHz (16 m)

Circuit Features

Loudspeaker 4 ohms

Output power 100 mW

Antennas

Telescopic antenna FM and SW

Ferrite rod antenna MW

Sockets

Headphones Socket 3.5mm dia.

DC Socket 4.0mm dia. Centre pin negative

Guarantee

This receiver is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge.

The guarantee does not cover:

1. Damage resulting from incorrect use.

2. Consequential damage.

3. Receivers with removed or defaced serial numbers.

4. Telescopic aerials.

Procedure: Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer

will be able to attend to any defect quickly and efficiently but should it be necessary the dealer will return the instrument to the Company’s service department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please contact Roberts Radio Technical Services department at the address shown on the rear of this manual before taking further action.

These statements do not affect the statutory rights of a consumer.

If you need any further advice, please call our Technical Helpline on :020 8758 0338 (Mon-Fri)

Issue 2

ROBERTS RADIO TECHNICAL SERVICES

97-99 Worton Road

Isleworth Middlesex

TW7 6EG

Technical Helpline:- 020 8758 0338 (Mon-Fri)

Website: http://www.robertsradio.co.uk

Roberts Radio R9968 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual