RME FF-TCO Time Code Option fireface_800_tco_e.pdf

FIREFACE 800 TIME CODE OPTION

Optional Fireface 800 synchronization module

Overview

The TCO module is an optional extension for the Fireface 800 option slot.

The little module provides the Fireface with a Word Clock input and oers a synchronization to LTC and video. Thanks

to SteadyClock(TM), the TCO not only extracts absolute positions from these signals, but also a very clean low-jitter

word clock. Thus a sample accurate timecode synchronization to audio or video sources is assured.

Features

LTC can be derived and generated in all common formats, i.e. 24, 25, 30, and 29.97 frames; drop-frame or non-

dropframe. Commonly used Pull-Up- und Pull-Down Formats (+/- 0.1% und +/- 4%) can be utilised, and PAL and

NTSC video formats will be automatically detected and processed.

The received Time Code can be sent to the audio or video application as ASIO Positioning Protocol (APP) or MTC. An

application can send APP or MTC to the TCO, which will generate LTC on hardware level with lowest jitter (no software/

driver routine). Several y-wheel functions facilitate chase operation (adjustable drop-out length, Continuous- or

Jam-Sync).

Under Windows XP the HDSP provides the SMPTE position as APP (ASIO Positioning Protocol) and as MTC Sync. Under

Mac OS X the TCO-FF provides the SMPTE position as MTC Sync.

The TCO has a combined switchable Word Clock/Video input (BNC) as well as an LTC input (BNC). The Word Clock /

Video input on the card can comfortably be terminated (relay-controlled) with a 75 Ohm terminator from the settings

dialog.

Connectivity

1 x Wordclock/Video Sync Input

1 x LTC I/O

The TCO also features an additional LTC output (BNC) with two level settings (congurable via jumper).

Engineered and Made in Germany

1 / 2

Settings

All settings can be accessed conveniently from an additional page in the settings dialog of the Fireface 800.

The clear and easy dialog site appears automatically after a TCO is installed. On the main page the new sync-option TCO can be selected.

The dialog provides all important options: Sync-Source (LTC, Video or Word Clock), termination for BNC input (75 Ohm), Frame Rate of the incoming SMPTE signals and WCK

Conversion.

Furthermore the TCO dialog shows Pull-Up- and Pull-Down-factors and state information (Input State) about the incoming signal. E.g. an incoming word clock signal is

analyzed and displayed to be in the Single Speed, Double Speed or Quad Speed range.

Tech Specs

LTC In

BNC unbalanced

Level range: -25 dBu up to +12 dBu

Video In (Word Clock In)

BNC unbalanced switchable termination 75 Ohm

Format: PAL and NTSC

LTC Out

BNC

Output level: +4 dBu, via Jumper –7 dBu

Outputs impedance: 220 Ohm

Power supply via ribbon cable, 5 V DC, 100 mA

Standard bracket, dimensions PCB (WxD): 98 x 75 mm

Worldwide Distribution

Am Pfanderling 60 . 85778 Haimhausen . Germany

Tel.: [phone] Fax: [phone]

www.rme-audio.de

2 / 2