Rival FRRVMN01 Owner's Manual

SERVICE INSTRUCTIONS
1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the Warranty.
2. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed Warranty.
3. If you have any questions or comments regarding this unit’s operation or believe any repair is necessary, please write to our Consumer Service Department or visit our website at www.rivalproducts.com.
1-800-557-4825
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty.
This warranty does not cover normal wear of par ts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition.
Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty.
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the
product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A. If you have any question regarding this warranty or would like to obtain warranty service, please call 1-800-557-4825 and a
convenient service center address will be provided to you. In Canada
If you have any question regarding this warranty or would like to obtain warranty service, please call 1-800-557-4825 and a convenient service center address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO NOT RETURN THIS PRODUCT TO
ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
© 2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
153092 FRRVMN01_11ESM1 Printed in China GCDS-RIV23262-PH
1 YEAR LIMITED WARRANTY
Manual Snow Cone Maker
Owner’s Guide
READ AND SAVE THESE INSTRUCTIONS
FRRVMN01_11ESM1.indd 1-2 9/30/11 4:25 PM
IMPORTANT SAFEGUARDS
KNOW YOUR MANUAL SNOW CONE
When using appliances, basic safety precautions should always be followed, including the following:
1. Read all instructions.
2. Close supervision is necessary when any appliance is used near
children. This appliance should never be used by children.
3. Avoid contact with moving parts.
4.
The use of appliances not recommended or sold by the manufacturer may cause fire or injury.
5. Do not use outdoors.
6. Never place fingers or other utensils into feed or discharge areas.
7. Check ice shaver for presence of foreign objects before using.
8. Blades are sharp. Handle carefully.
9. Be certain COVER is securely locked in place before operating
appliance. Do not attempt to defeat the COVER interlock mechanism.
10. Do not use extension cord.
SAVE THESE INSTRUCTIONS
This appliance is for HOUSEHOLD USE ONLY. No user-serviceable parts inside. Power unit never needs lubrication. Do not attempt to service this product. Any servicing should be performed by an authorized service representative.
MAKER
COVER
DASHER
HOUSING
PLASTIC CUP
PLASTIC CUP LID
-E2-
FRRVMN01_11ESM1.indd 3-4 9/30/11 4:25 PM
-E3-
HOW TO USE YOUR MANUAL SNOW CONE MAKER HOW TO CLEAN YOUR MANUAL SNOW CONE MAKER
NOTE: Never touch the blade at any point during use of this unit.
1. Remove top cover by unscrewing counter-clockwise.
2. Pour ice-cubes into the unit leaving about half an inch from the top.
3. Place the top cover back with slight pressure to force the spring to stretch and then twist clockwise to lock in place, all in one motion.
4. Place plastic cup under the unit to catch shaved ice
NOTE: Hold unit firmly when in use
5. Hold Lever and rotate in clockwise motion (while holding the unit) to grind the ice.
6. Clean all excess ice/water from unit after use.
NOTE: Occasionally ice may build up and will get lodged in the chute.
If ice is not coming out of the chute gently shake the unit to ensure the ice is not frozen together.
CAUTION: Do not allow children to operate this appliance. The Ice Shaver is for household use only. Do not attempt to sharpen the BLADE.
CAUTION: The stainless steel BLADE is very sharp. Never attempt to touch the tip of the BLADE when operating, assembling, disassembling, or cleaning.
1. Unlock the cover by rotating counter-clockwise. Lift to remove.
2. (Optional) You may rinse unit through by spraying it with water.
3. Wipe down all parts and surfaces with clean damp cloth.
4. Make sure all components are completely dry before storage.
CAUTION: Do not soak in water.
Questions? Please contact us at
www.rivalproducts.com or at 1.800.557.4825.
-E4- -E5-
FRRVMN01_11ESM1.indd 5-6 9/30/11 4:25 PM
Loading...
+ 5 hidden pages