Rinnai RINV34RC, RINV25RC, RINV51RC Installation Manual

ON/OFF

Installation Manual

Split Type Wall Mounted Air Conditioner

Models: RINV25RC / RINV34RC / RINV51RC / RINV70RC

RUN

COOL

TURBO

SPEED

SWING

LRSWING

FAN

COOL

HEAT

SWING

This appliance shall be installed in accordance with:

• Manufacturer’s Installation Instructions

• Current AS/NZS 3000

• Local Regulations and Municipal Building Codes including local OH&S requirements This appliance must be installed, maintained and removed by an Authorised Person. For continued safety of this appliance it must be installed and maintained in

accordance with the manufacturers instructions.

This page is intentionally blank

Rinnai 2 Split AC IM

TABLE OF CONTENTS

Warnings and Important Information 4

INSTALLATION General 7

Contents Checklist �� 7

Appliance Components �� 7

Weights & Dimensions �� 7

Location 8

Indoor Unit �� 8

Outdoor Unit �� 8

Pipe Length & Elevation Limits �� 8

Installation 9

Indoor Unit �� 9

Wall Mounting Plate ��9

Wall Penetration �� 9

Drain Pipe �� 9

Electrical Connections �� 10

Wall Installation ��10

Outdoor Unit �� 11

Electrical Connections �� 11

DRED Connection (optional) �� 12

Condensate Drain Installation �� 12

Refrigerant pipes �� 13

Flaring �� 13

Connecting Vapour / Liquid Pipes To Indoor & Outdoor Units �� 13

Air purging & Leakage Test �� 14

Evacuation Vacuum Method / Leak Test �� 14

Adding refrigerant for longer line length �� 14

Final Checklist �� 15

Contacts 16

Rinnai 3 Split AC IM

WARNING

IMPORTANT

WARNINGS AND IMPORTANT INFORMATION

READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.

Always comply with the following precautions to avoid dangerous situations and to ensure optimum performance�

Failure to carefully read and follow all instructions in this manual can result in equipment malfunction, property damage, personal injury and/or death�

WARNINGS: WHEN IGNORED, CAN RESULT IN SERIOUS INJURY OR DEATH.

CAUTIONS: WHEN IGNORED, CAN RESULT IN MINOR INJURY OR PRODUCT DAMAGE.

REGULATORY / INSTALLATION

This appliance shall be installed in accordance with:

Manufacturer’s Installation Instructions�

Current AS/NZS 3000�

Local Regulations and Municipal Building Codes including local OH&S requirements�

This appliance must be installed, maintained and removed by an Authorised Person�

For continued safety of this appliance it must be installed and maintained in accordance with the manufacturers instructions�

This appliance uses R410A refrigerant�

This appliance is heavy, use 2 people or mechanical lifting device� Improper lifting may result in serious injury�

Take care when opening or unpacking this appliance� Failure to do so may result in serious injury or product failure�

DO NOT modify the electrical wiring of this appliance� If the control power wiring is damaged or deteriorated then it must be replaced by an authorized person� Failure to do so may result in electric

shock, re, serious injury or product failure.

DO NOT install the air conditioner on an unstable or non level surface or where there may be a danger of it falling� It may result in death, serious injury, or product failure�

DO NOT install the outdoor unit where noise may cause nuisance�

DO NOT install the outdoor unit where it will be exposed to sea wind (salt spray) as this will reduce

durability�

OPERATION RANGE LIMITATIONS

The table below indicates the temperature ranges the air conditioner can be operated within�

MODE TEMPERATURE SOURCE

MINIMUM

OPERATION

TEMPERATURE

MAXIMUM

OPERATION

TEMPERATURE

Cooling / Heating

Rinnai 4 Split AC IM

Adjustable inside temperature 16°C 32°C

Ambient outside temperature -12°C 47°C

WARNING

WARNINGS AND IMPORTANT INFORMATION

INSTALLATION WARNING

This appliance shall be installed in accordance with local electrical safety regulations by an authorised person such as a licensed electrician�

This appliance is Type 1 Electrical Appliance�

Make sure the live wire, neutral wire and earth wire in the power socket are properly connected�

Inadequate or incorrect electrical connections may cause re or electric shock.

The yellow-green wire in air conditioner is the earthing wire which cannot be used for other purposes� Improper earthing may cause electric shock�

The circuit breaker must have the functions of magnetic tripping and heat tripping to prevent short circuit and overload�

Use a standard circuit breaker and fuse conforming with the rating of the appliances�

Model Circuit Breaker (Amps)

RINV25RC 10

RINV34RC 10

RINV51RC 15

RINV70RC 20

The unit must be earthed in accordance with local regulations�

Connect all wiring tightly� Failure to do so may result in electric shock or product failure�

Do not supply power to the unit until all wiring and tubing are completed�

Select an installation location where the components can be mounted securely and accessible for service and replacement�

Make sure tubing is properly insulated to ensure optimum performance�

Install the drain hose properly for smooth drainage of condensed water�

Make sure to check for and rectify any refrigerant leaks after you install or repair the unit�

Rinnai 5 Split AC IM

+ 11 hidden pages