Rice Lake G-2 User Manual

Place printer feet

into recessed holes

in enclosure base

Prodigy Max / I-Class Series

GUARDIAN Printer Enclosure Instructions

1. Open GUARDIAN Cover

With a hex wrench, loosen the two lockdown screws holding the cover closed. Release the latch on the front and open the cover.

Release latch

2. Remove Cable Block

Remove the hex head cap screw that holds the cable block. After you have removed the screw, pull the cable block away from the base. This will allo w you to run your cables through the enclosure to your printer.

Remove screw and

cable block

4. Set the Printer into the Enclosure and Attach Cables and Cable Block

Place the printer onto the base of the enclosure. The printer footpads ﬁt into the recessed holes in the base of the enclosure.

Attach the necessary cables and power cord to the printer. Route the cables and power cord through the cutout where the cable block is installed.

Reinstall the cable entry block. The cables and power cord should be pinched between the gasket of the base and the cable entry block. Insert the hex cap screw through the cable entry block and tighten so that the gasket compresses around the cables.

3. Printer Preparation

Before placing the printer in the GUARDIAN enclosure, remove the label access cover from printer.

Printer

NOTE: I-Class Series Printers; remove additional

Peel and Present plastic cover from printer prior to placing the printer into the enclosure.

February 2001 63900

Label access

cover

Peel and

Present cover

Place cables and

power cord in

open space

Tighten screw until

cable block firmly

clamps cables and

power cord

5. Close Cover and Begin Printing

Close and latch the cover. Tighten the lockdown screws. Open the label access door and begin printing labels.