Rice Lake 820i User Manual

820i™ Programmable HMI Indicator/Controller

PANEL CUTOUT
(DASHED LINE)

INTERIOR HOUSING
(DOTTED LINE)

8.02"

9.16"

11.56"

10.51"

OUTER PERIMETER OF
EXTERIOR FACEPLATE
(SOLID LINE)

To be the best by ever y measure

Panel Mount Enclosure Installation Instructions

PNs 93424 and 93425

This document contains drawings, replacement parts
lists, and instructions for installing panel mount
models of
Manual, PN 93018, for general installation and
configuration and calibration information.

820i indicators. See the 820i Installation

The 820i has no on/off switch. Before
opening the unit, ensure the power cord
is disconnected from the power outlet.

• Use a wrist strap to ground yourself and protect
components from electrostatic discharge (ESD) when
working inside the indicator enclosure.

• This unit uses double pole/neutral fusing which could
create an electric shock hazard. Procedures requiring
work inside the indicator must be performed by
qualified service personnel only.

• The supply cord serves as the power disconnect for the

820i. The power outlet supplying the indicator must be

installed near the unit and be easily accessible.

January 2007 95304

Figure 1. Panel Cutout for Panel Mount Enclosure

Installation

11.56"

7.95"

5.20"

9.16"

10.38"

BACK VIEW

Display

Use the dimensions shown in Figure 1 on page 1 to lay out the panel cutout for the panel mount enclosure. See
Figure 2 on page 2 for enclosure dimensions.

Figure 2. Panel Mount Enclosure Dimensions

Once the cutout has been prepared, slide the enclosure into the cutout from the front of the panel. Slide the
clinching bracket around the enclosure from inside the panel. Secure the bracket to the enclosure using the six 1/4"
screws provided in the parts kit (PN 94435), then use the nine 1-1/2" screws (PN 82425) to secure the clinching
bracket to the panel door. See

Figure 3.

Figure 3. Clinching Bracket Assembly

2 820i Panel Mount Installation Instructions