Revo RECDH409-1 User Manual

INSTRUCTION MANUAL

3-AXIS PLASTIC DOME CAMERA

540TV Lines Super

High Resolution Color Camera

WARNINGS AND CAUTIONS:

CAUTION:

CAUTIONCAUTION

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER(OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

EXPLANATION OF GRAPHICAL SYMBOLS

The lightning flash with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the product.

Should any liquid or solid object fall into the cabinet,
unplug the unit and have it checked by the qualified
personnel before operating it any further.

Unplug the unit from the wall oulet if it is not going to
be used for several days or more. To disconnect the
cord, pull it out by the plug. Never pull the cord itself.

Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials(curtains, draperies)
that may block the ventilation holes.

Height and vertical linearity controls located at the
rear panel are for special adjustments by qualified
personnel only.

Do not install the unit in an extremely hot or
humid place or in a place subject to excessive
dust, mechanical vibration.

The unit is not designed to be waterproof.
Exposure to rain or water may damage the unit.

Clean the unit with a slightly damp soft cloth.
Use a mild household detergent. Never use
strong solvents such as thinner or benzine as
they might damage the finish of the unit.

Retain the original carton and packing
materials for safe transport of this unit in the
future.

Safety ----------------------------------------- Installation -----------------------------------

Cleaning --------------------------------------

PRECAUTIONS

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR
MOISTURE. DO NOT INSERT ANY METALLIC OBJECTS THROUGH THE VENTILATION GRILLS OR
OTHER OPENINGS ON THE EQUIPMENT.

i

FCC INFORMATION : THIS EQUIPMENT HAS BEEN TESTED

AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL
DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE
LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION
AGAINST HARMFUL INTERFERENCE WHEN THE EQUIPMENT IS
OPERATED IN A COMMERCIAL ENVIRONMENT. THIS EQUIPMENT
GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY
ENERGY AND IF NOT INSTALLED AND USED IN ACCORDANCE WITH
THE INSTRUCTION MANUAL, MAY CAUSE HARMFUL INTERFERENCE
TO RADIO COMMUNICATIONS. OPERATION OF THIS EQUIPMENT IN
A RESIDENTIAL AREA IS LIKELY TO CAUSE HARMFUL
INTERFERENCE IN WHICH CASE THE USER WILL BE REQUIRED TO
CORRECT THE INTERFERENCE AT HIS OWN EXPENSE.

CAUTION : CHANGES OR MODIFICATIONS NOT EXPRESSLY

APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE
COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.

THIS CLASS A DIGITAL APPARATUS COMPLIES WITH CANADIAN
ICES-003.

NORME NMB-003 DU CANADA.

WARNING

This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be required
to take adequate measures.

CE COMPLIANCE STATEMENT

FCC COMPLIANCE STATEMENT

ii

IMPORTANT SAFEGUARDS

1 -1 Class 2 power source only.

7

-2 Do NOT use power source other than that specified.

17

17. CAUTION- these servicin g instructions are

for use by qualifie d service person nel only.
to redu ce the risk of elec tric shock do no t
perfor m any servicing ot her than that co ntained
in the op erating instru ctions unless you are
qual ified to do so.

5. ACCESSORIES

iii

TABLE OF CONTENTS

INTRODUCTION

CAMERA CONNECTION

BASIC CAMERA INSTALLATION

INSTALLING & ADJUSTING CAMERA MODULE

BASE INSTALLATION

FUNCTION SWITCH

DC AUTO IRIS ADJUSTMENT

TROUBLESHOOTING AND MAINTENANCE

SPECIFICATIONS

EXTERNAL DIMENSION

LENS ADJUSTMENT

DC AUTO IRIS LENS

1

2

3

4

5

7

8

8

8

9

10

11

iv