Page 1
Modzilla
™
1
Safety Precautions:
Warning: Do not modify or alter this unit. Changes or modi cations to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
• This vehicle is suitable for indoor or outdoor use in
dry conditions.
•
The vehicle is suitable for ages 14 and above. Parents
should supervise children who operate the vehicle.
•
Remove batteries from the transmitter when not in use.
• Switch off the vehicle and disconnect the battery
when it is not in use.
• Keep hands, face and loose clothing away from the
vehicle.
• Keep these instructions for future reference.
• Always keep an eye on the vehicle. Careless or
irresponsible use may cause damage.
• Always follow these instructions when operating this
vehicle.
• Do not operate near people, animals or water.
Battery Requirements for Transmitter:
3 x 1.5V AA size batteries (included)
Care and Maintenance:
• Regularly examine all parts for damage. If any is found,
do not use again until the damage has been repaired.
• Use a clean cloth to wipe the vehicle clean.
• Keep the vehicle and batteries away from direct
sunlight and/or heat sources.
Battery Cautions:
• Parental guidance is recommended when installing or
replacing batteries.
• For best performance, use new alkaline batteries in
transmitter.
• Insert new batteries in the transmitter as soon as any
function becomes diminished.
• Do not power transmitter by mixing different types of
batteries, or old and new batteries.
• Use only batteries of the same or equivalent type as
those recommended.
The vehicle is equipped with a LiPo battery. Always
follow these safety instructions:
• ALWAYS disconnect the battery from the vehicle when
not in use.
• Only use the included charger.
• Do not attempt to use this charger with NiCd or NiMH
battery packs.
• Do not attempt to use a damaged battery.
• LiPo batteries must be recycled or disposed of properly.
• Do not leave the charger unattended while charging.
Disconnect the battery and unplug the charger
immediately if either becomes hot! However, it is
normal for the charger to get warm.
• Disconnect the battery from the charger and carefully
move the battery to a reproof location if the battery
begins to swell or smoke!
• Never allow the battery temperature to exceed 140°
F [60° C].
•
Do not attempt to charge a battery if it is swollen or hot.
• Do not place the charger or any battery on a ammable
surface or near combustible materials while in use.
• Never disassemble or modify pack wiring in any way
or puncture cells.
• Never charge inside a vehicle.
• Always disconnect the battery and remove the charger
from the USB port when not in use.
• ALWAYS keep a supply of sand accessible when
charging. Dumping sand on the battery will extinguish
a LiPo chemical re.
• ALWAYS KEEP OUT OF REACH OF CHILDREN
90 DAY LIMITED WARRANTY
PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE – Revell will repair or replace factory defects for 90 days from the date of purchase. This warranty speci cally does not
cover crash damage, misuse or abuse. To make a warranty claim, please contact our product support team at 1-217-398-8970 or e-mail us at productsupport@hobbico.com.
If requested by Product Support, please send defective product to: Hobby Services, 3002 N Apollo Dr., Suite #1, Champaign, IL 61822.
This warranty applies only if the product is operated in compliance with the instructions and warnings provided with each model. Revell assumes no liability except for
the exclusive remedy or repair of parts as speci ed above. Revell shall not be liable for consequential or incidental damages. Some states do not allow the exclusion of
consequential or incidental damages so the above exclusion may not apply to you. This warranty gives you speci c legal rights and you may also have other rights which vary
from state to state.
Contents
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
Any changes or modi cations not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator (transmitter) and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC REQUIREMENT
Radio Controlled Truck
Radio Controlled Truck
Transmitter
AA Batteries
Charger
Battery
Page 2
Steering
Throttle
Steering Trim
Power Switch
2
Vehicle and Transmitter Parts
1. Slide the battery cover from the bottom of the
transmitter.
2. Insert (3) 1.5V AA batteries, following the polarity
information.
3. Re-install the battery cover.
Insert Batteries into the Transmitter
ESC Switch
Motor
LiPo Battery
LiPo Battery
Connector
Page 3
3
Charging Procedure
Driving the Vehicle
Getting Started:
Operation:
1. Move the ESC switch to the “on” position.
2. Turn the transmitter on, by sliding the power switch to the
“on” position. The red LED should illuminate. If the LED does not
illuminate check that the batteries are installed correctly in the
transmitter and that the batteries are in good condition.
3. When you are nished driving, turn the truck off then the
transmitter. Make sure you always unplug the battery from the
truck once you are nished running. Failure to disconnect the
battery will cause a slow drain on the battery which could cause
damage to it.
NOTE: You must turn the vehicle on before the transmitter for
the transmitter and receiver to link properly.
ATTENTION: • Allow the battery to cool off for 10-15 minutes before recharging.
• Do not leave the battery unattended during the charging process.
• Charge times will vary depending on how much charge is left in the battery.
3. Disconnect the battery from the charger and
reconnect the battery to the speed control.
2. The charging process takes approximately 3.5
hours. For safety reasons, never charge the
battery for longer than 4 hours. While charging,
the red charger LED will be on. When the battery is
nished, the green charger LED will be on.
1. Switch off the car.
2. Carefully plug the charger into the USB port on
your computer or USB adapter.
3. Plug the vehicles lipo battery into the charger.
NOTE: You must plug the charger into the USB
port/adapter rst before plugging the battery
into the charger for the charger to perform
properly.
LED Charge
Indicator
• To slowly drive forward, pull the trigger slightly. To drive
faster, pull the trigger further.
• To brake, push the trigger. To drive in reverse, push again.
• During a crash, release the trigger.
• To turn, rotate the wheel to the left or right.
• Always move the controls slowly and with a gentle touch.
• When the vehicle battery becomes low, the vehicle will roll to a stop. The vehicle is equipped with a LVC (Low Voltage Cutoff) to protect the battery.
• Allow the battery to cool before recharging.
Page 4
4
revell.com
Linking Procedure
The Modzilla is equipped with an auto linking feature which allows the transmitter and receiver to automatically link once they are
turned on. Make sure to turn the transmitter on before the vehicle.
Troubleshooting
Service
If your Modzilla™ requires repairs or replacement, DO
NOT RETURN TO RETAILER. Contact:
Hobby Services
3002 N. Apollo Drive, Suite 1
Champaign, Il, 61822, U.S.A.
9am-5pm Central Mon.-Fri.
(217) 398-0007
hobbyservices@hobbico.com
Problem: The wheels won’t turn.
Solution: Recharge the battery.
Problem: The transmitter doesn’t function.
Solution: Make sure the batteries are inserted correctly.
Insert new batteries.
Problem: The vehicle loses speed or comes to a stop.
Solution: Recharge the battery.
Problem: Transmitter LED ashing slowly (low voltage).
Solution: Replace the transmitter batteries.
REVELL, INC. 1850 HOWARD ST., UNIT A, ELK GROVE VILLAGE, IL 60007 U.S.A.
MADE IN SHANGHAI, CHINA
PLEASE RETAIN PACKAGING FOR FUTURE REFERENCE. CONTENTS AND
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2015 REVELL INC. A SUBSIDIARY OF HOBBICO, INC.
Steering Trim: Driving Tips:
Driving the Vehicle (continued)
• Run the vehicle on a at surface.
• Watch the vehicle instead of looking at the transmitter.
• Always release the throttle trigger right away following a crash to prevent
damaging the electronics.
• The vehicle should be operated in an area that has as much open space as
possible with no people or animals nearby.
• Do not operate this vehicle on the street.
• If the vehicle pulls right (when viewed from
behind), rotate the knob to the left.
• If the vehicle pulls left (when viewed from
behind), rotate the knob to the right.
Steering Trim Button
Loading...