RCA WP4UWR Owner's Manual

USB wall plate charger WP4UWR/WP4UAR User’s Guide

The RCA USB wall plate charger turns any standard home dual AC power outlet into a USB outlet in seconds, with fast, full-speed charging for smartphones or tablets.

The 4 USB charging outlets support a wide range of USB-powered portable devices. The outlets labeled 2.1 are optimized for devices that require extra current, such as tablets. These outlets can output 2.1 Amps of power.

The bottom 2.1 outlet is switchable, to support tablet products with different charging circuitries. If you notice that your tablet is not charging correctly on the top 2.1 outlet, follow the instructions below to charge it on the switchable 2.1 outlet.

All four outlets support regular USB-powered devices, such as most smartphones.

Using the Switchable 2.1 USB Outlet

The bottom 2.1 USB outlet is switchable to support the different charging circuitries used by different tablet manufacturers. This outlet can charge smart phones with non-standard USB as well as tablets. Before using this outlet, make sure you have the switch below this outlet set to the right position for your device, as shown here. You must have it set BEFORE you plug in your device. As a rule of thumb, leave this switch in the B position unless you have an Apple (A) or Samsung (C) product.

Notes:

• These are general guidelines for setting the switch—they might not work for all

models of all brands listed. If your device is still not charging correctly, unplug it and try a different setting.

• If your device does not start charging after plugged in, remove the USB cable

from the outlet. Set the switch to a different position and reinsert the USB cable to the outlet. You may need to try all three positions.

A: Optimized for iPad and other Apple products (except for iPod Classic and nano)

2.1

B: Works for most other devices

C: Optimized for Samsung tablets

WP4UWR/WP4UAR US QSG 00

Limited Lifetime Warranty

Audiovox Accessories Corporation (the “Company”) warrants to you the original retail purchaser of this product that should it, under normal use and conditions, be proven defective in material or workmanship during its lifetime while you own it, such defect(s) will be repaired or replaced (at the Company’s option) without charge for parts and repair labor.To obtain repair or replacement within the terms of this Warranty, the product is to be delivered with proof of warranty coverage (e.g. dated bill of sale), speciﬁ cation of defect(s), transportation prepaid, to the Company at the address shown below. Do not return this product to the Retailer.This Warranty does not cover product purchased, serviced or used outside the United States or Canada.This Warranty is not transferable and does not extend to costs incurred for installation, removal or reinstallation of the product. This Warranty does not apply if in the Company’s opinion, the product has been damaged through alteration, improper installation, mishandling, misuse, neglect, or accident. THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT.This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE SHALL BE LIMITED TO DURATION OF THIS WARRANTY. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER. No person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product.Some states/ provinces do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you. This Warranty gives you speciﬁ c legal rights and you may also have other rights which vary from state/province to state/province.

U.S.A.: Audiovox Return Center, 150 Marcus Blvd., Hauppauge, New York 11788

CANADA: Audiovox Return Center, c/o Genco, 6685 Kennedy Road, Unit 3, Door 16, Mississauga, Ontario L5T 3A5

• The switch controls the bottom 2.1 outlet only. It does not control the other

charging outlets.

• When this charger is providing maximum charging power (like with two fully

discharged tablets, four fully discharged phones), it is not unusual for the outside case of the wall plate charger to become warm to the touch. This is normal. You should not hold on to the case when it is warm, although it is safe to touch.

Note about tablet charging:

This wall plate charger has 2 banks of 2 USB charging outlets each. Each bank provides enough power for full-speed charging for 1 tablet or 2 smartphones. In other words, the wall plate charger can provide full-speed charging for up to 2 tablets or 4 smartphones at the same time. For full-speed charging of tablets, you should charge it by itself in its bank--you can still use the other bank for either a single tablet or 2 smartphones, as shown here.

2.1

1 tablet and 2 smartphones2 tablets 4 smartphones

El cargador de placa para pared USB RCA convierte cualquier toma de pared CA dual doméstica estándar en una toma USB en segundos, proporcionando una carga rápida a toda velocidad para teléfonos inteligentes o tabletas.

Las 4 tomas de carga USB soportan una amplia variedad de dispositivos portátiles alimentados vía USB. Las tomas etiquetadas 2.1 están optimizadas para dispositivos que requieran corriente extra, tales como tabletas. Éstas tomas pueden dar salida a 2.1 Amperes de corriente.

La tabla 2.1 inferior es conmutable, para dar soporte a productos de tabletas con diferentes circuitos de carga. Si usted nota que su tableta no está cargando correctamente en la toma 2.1 superior, siga las instrucciones a continuación para cargarla en la toma 2.1 conmutable.

Las cuatro tomas soportan dispositivos alimentados vía USB regulares, tales como la mayor parte de los teléfonos inteligentes.

Uso de la toma USB 2.1 conmutable

La toma USB 2.1 inferior es conmutable para soportar los diferentes circuitos de carga usados por diferentes fabricantes de tabletas. Esta toma puede cargar teléfonos inteligentes con USB no estándar así como tabletas. Antes de usar esta toma, asegúrese de que tenga el interruptor bajo esta toma establecido en la posición correcta para su dispositivo, tal como se muestra aquí. Esto debe ser efectuado ANTES de conectar su dispositivo. Como regla general, deje este interruptor en la posición B a menos que usted tenga un producto de la marca Apple (A) o Samsung (C).

Notas:

• Estos son lineamientos generales para conﬁ gurar el interruptor - pueden no

funcionar para todos los modelos de todas las marcas listadas. Si su dispositivo aún no está cargando correctamente, desconéctelo e intente con una conﬁ guración diferente.