Raytac MDBT42Q Users Manual

Version: A
Issued Date: 2016/03/24
Approval Sheet
(產品承認書)
產品名稱 (Product): BT 4.2 Module (nRF52832)
產品型號 (Model No.): MDBT42Q Series
Advantage of MDBT42Q series:
Index
1. Overall Introduction ...................................................................................................... 1
1.1. Application ............................................................................................................ 1
1.2. Features ............................................................................................................... 2
1.3. Profile & Service Information ................................................................................ 3
2. Product Dimension ....................................................................................................... 4
2.1. MDBT42Q Series ................................................................................................. 4
2.2. Pin Assignment ..................................................................................................... 9
2.3. GPIO Located Near the Radio ............................................................................. 11
3. Main Chip Solution ....................................................................................................... 11
4. Specification ................................................................................................................ 12
4.1. Absolute Maximum Ratings ................................................................................ 12
4.2. Operation Conditions .......................................................................................... 12
4.3. Electrical Specifications ...................................................................................... 12
4.4. General Radio Characteristics ............................................................................ 12
4.5. Radio Current Consumption (Transmitter) .......................................................... 13
4.6. Radio Current Consumption (Receiver) .............................................................. 13
4.7. Transmitter Specification .................................................................................... 14
4.8. Receiver Operation ............................................................................................. 14
4.9. RX Selectivity ..................................................................................................... 14
5. FCC Compliance .......................................................................................................... 18
6. IC Caution .................................................................................................................... 20
7. NCC 警語 ...................................................................................................................... 21
1
1. Overall Introduction
Raytacs MDBT42Q is a BT 4.0, BT 4.1 and BT 4.2 stack (Bluetooth low energy or BLE) module designed based on Nordic nRF52832 SoC solution, which incorporates: GPIO, SPI, UART, I2C, I2S, PWM and ADC interfaces for connecting peripherals and sensors.
Features of the module:
1. Dual Transmission mode of BLE & 2.4Ghz RF upon customer preference.
2. Compact size with (L) 16 x (W) 10 x (H) 2.2 mm.
3. Low power requirements, ultra-low peak, average and idle mode power consumption.
4. Be compatible with a large installed base of mobile phones, tablets and computers.
5. Fully coverage of BLE software stack. See 1.3 Profile & Service Information.
6. BLE & RF transmission switching helps products fit all operation system and most hardware.
1.1. Application
IoT
Home automationSensor networksBuilding automation
Personal Area Networks
Health / fitness sensor and monitor deviceMedical devicesKey-fobs and wrist watches
Interactive entertainment devices
Remote control
Gaming controllerBeaconsA4WP wireless chargers and devicesRemote control toysComputer peripherals and I/O devices
Mouse
Keyboard
Multi-touch trackpad
2
1.2. Features
Multi-protocol 2.4GHz radio32-bit ARM Cortex – M4F processor512KB flash programmed memory and 64KB RAMSoftware stacks available as downloadsApplication development independent from protocol stackOn-air compatible with nRF51, nRF24AP and nRF24L seriesProgrammable output power from +4dBm to -20dBmRSSIRAM mapped FIFOs using EasyDMADynamic on-air payload length up to 256 bytesFlexible and configurable 32 pin GPIOProgrammable peripheral interface - PPISimple ON / OFF global power modeFull set of digital interface all with Easy DMA including:
3 x Hardware SPI master ; 3 x Hardware SPI slave2 x two-wire master ; 2 x two-wire slave1 x UART (CTS / RTS)PDM for digital microphone
I2S for audioQuadrature demodulator12-bit / 200KSPS ADC128-bit AES ECB / CCM / AAR co-processorLowe cost external crystal 32MHz ± 40ppm for Bluetooth ; ± 50ppm for ANT PlusLowe power 32MHz crystal and RC oscillatorsWide supply voltage range 1.7V to 3.6VOn-chip DC/DC buck converterIndividual power management for all peripheralsTimer counter
5 x 32-bit
3 x 24-bit RTCNFC-A tag interface for OOB pairing
3
Profile Description
Service Description
Alert Notification Profile
Alert Notification Service
Blood Pressure Profile
Blood Pressure Service
Device Information Service
Cycling Speed & Cadence Profile
Cycling Speed & Cadence Service
Device Information Service
Glucose Profile
Glucose Service
Device Information Service
Health Thermometer Profile
Health Thermometer Service
Device Information Service
Heart Rate Profile
Heart Rate Service
Device Information Service
HID over GATT Profile
HID Service
Battery Service
Proximity Profile
Link Loss Service
Immediate Alert Service
TX Power Service
Running Speed & Cadence Profile
Running Speed & Cadence Service
Device Information Service
1.3. Profile & Service Information
Profile & Service are supported by MDBT40Q as below:
4
2. Product Dimension
2.1. MDBT42Q Series
PCB Dimensions, Pin Indication and Layout Guide
PCB SIZE: (L) 16 x (W) 10 x (H) 2.2 mm
5
6
Loading...
+ 16 hidden pages