FT 45
CROSSFADER
Fader Removal
1. Remove the three fader knobs by
gently pulling up.
2. Remove the four screws securing the
cover plate (see Figure 1) with a #1
Phillips screwdriver.
3. Carefully remove cover plate.
4. Remove the two mounting screws (shown
in Figure 2) with a #1 screwdriver,
while holding the fader in place.
5. Slide fader to one side and bring through
hole in panel.
6. Remove ribbon cable from the fader
assembly.
TTM 54 PER FORMAN CE MIX ER
Figure 1
10024
Fader Installation
1. Plug ribbon cable onto fader assembly.
2. Feed replacement fader through hole.
3. While holding fader in place, install
the two mounting screws supplied
with the replacement fader. (see
Figure 2)
4. Carefully place the cover plate back
onto unit.
5. Install the four new mounting screws
supplied with the replacement
fader. (see Figure 1).
6. Place the three knobs back onto the
faders.
Figure 2
102401
Loading...