Radio Shack PGW170 User Manual

PGW170

PGW170

VHF WIRELESS GUITAR SYSTEM

SIGNAL

POWER

VOLUME

AUDIO

MAX

MIN

PGW170

INSTRUCTION MANUAL

VHF WIRELESS GUITAR SYSTEM

SIGNAL

POWER

VOLUME

AUDIO

MAX

MIN

PGW170

INSTRUCTION MANUAL

VHF WIRELESS GUITAR SYSTEM

OPERATION MANUAL

Thank you for buying the PGW170 VHF Wireless Guitar System.

Please read through these operation instructions so you will know
how to operate your model properly. After you read it, put it away
in a safe place for future reference.

Precautions

Receiver

Body pack transmitter

Installation

Specifications

Avoid exposure of the system to rain or moisture.

No user-serviceable parts inside the system. Refer all servicing to a qualified

technician only.

Handle the wireless system carefully, dropping or other shocks may cause

failure.

Avoid using the system where it may be subjected to heat, such as direct sunlight,

near radiators or other heat sources.

Should any liquid be spilt on the system, stop using it immediately. It may be

possible to dry the system, but you should have it checked by a qualified technician

before using it again.

Take care with the main power adapter and lead. If damaged in any way, do not use

the system and refer to a qualified technician for repair.

Only use the system with the supplied components. Do not attempt to use with any

other main power supply adapter .

If the is not going to be used for a while, remove the battery to

wireless system

prevent leakage. In the event of electrolyte leakage inside the battery compartment,

carefully remove the leakage with a damp cloth. Take care not to get battery

electrolyte in contact with your skin, however if it does, wash your hands under a

running tap. If electrolyte comes into contact with your eyes, seek medical advice

immediately.

Only replace the battery with the same or an equivalent type.

Please dispose of old batteries in an environmentally friendly manner in accordance

with the relevant legislation.

Do not use any solvents to clean any part of the .

wireless system

Switch on the guitar wireless system receiver unit by pressing the POWER switch

and the POWER light will illuminate to show the receiver unit is working. Raise the

antenna to the maximum height. Switch ON the guitar wireless transmitter, checking

that the red LED comes on for a second and then goes off. When the transmitter is

ON, the SIGNAL light will illuminate on the receiver unit.

1 2

The guitar wireless system is now ready for use. Adjust the volume and tone level of

your amplifier system as well as on the receiver & the bodypack as required. When

the guitar wireless system is not being used, turn OFF the guitar wireless system.

Note that switching the guitar wireless system on and off can cause interference that

will be heard if the guitar wireless system volume level of the amplifier system is still

set high.