Making Connections
BASIC
Connecting to Your TV Using an
RF Modulator (not supplied)
31-5029
5 DVD Home Theater in a Box
with Wireless Rear Speakers
Refer to your Owner’s Manual for complete instructions.
Connecting the Video
Output to Your TV
S-video Output to Your TV
Connecting the
BETTER
BEST
Connecting the
Component Video
Output to Your TV
Placing the Speakers
OR
Use the supplied video
cable to connect the
VIDEO OUT jack to a
video input on your TV.
Connecting the Speakers
OR
Use an S-video cable (not
supplied) to connect the
S-VIDEO OUT to an S-
video input on your TV.
OR
Use a component video cable
(not supplied) to connect the
COMPONENT VIDEO OUT
to a set of component inputs
on your TV.
1. Connect the WIRELESS (IN)
jack on the transmitter to the
WIRELESS (OUT) jack on
the rear panel of the receiver,
using the supplied RCA stereo
cord.
• Place the center speaker directly above or below the TV so that the
sound of the center channel is localized at the TV.
• Try to place all the speakers at an equal distance from the listening
position.
Listening to TV Audio
REMOTE CONTROL
Through the System
Installing
Batteries
2. Connect the supplied AC
adapter to the
DC IN inlet on
the rear panel of the unit.
Then plug the other end into
an AC power outlet.
The remote requires two
AA batteries (not supplied).
Connect a stereo
audio cable (not
supplied) from the
audio outputs of your
TV to the
TV IN jacks
on this system.
RadioShack and RadioShack.com are trademarksused by RadioShackCorporation.
• Make sure you disconnect power from all components.
• The wireless mode is the default setting.
• Connect each speaker using the color-coded speaker cable. Match them to the
colored labels above the speaker terminals.
• Do not connect any of the supplied speakers to any other amplifier. This may
result in malfunction or fire.
© 2003 RadioShack Corporation.
All RightsReserved.
RadioShack Corporation
Fort Worth, Texas 76102
ARH7078-A
04A03
Printed in Malaysia