Radio Shack 60-202 User Manual

60-202

Jeep® Wrangler® Unlimited

Driving Your Jeep

1. Thread the Jeep’s antenna wire through the supplied antenna tube. Then, insert the tube into the antenna tube holder on the Jeep’s body.

Thank you for purchasing your Jeep® Wrangler® Unlimited from RadioShack. Built to 1:14 scale, it can reach speeds of 650 feet per minute and comes in one of two frequencies (27 MHz or 49 MHz), so you can race with a friend. Please read this user’s guide before installing, setting up and using your Jeep.

What’s Included

lights when you turn on the Jeep.

Installing Batteries

2. Make sure the transmmitter and the Jeep are on the same band. Turn on the Jeep and transmitter. Your Jeep comes in 3 frequencies (Band ABC) so you can play with friends. Set your Jeep and transmitter to a different frequency than your friend’s.

3. Use the transmitter’s control levers to steer your Jeep.

4. Turn off the Jeep when you ﬁnish driving.

ON/OFF

Left Straight Right

Forward

Stop

Reverse

Band ABC

L / H – Switch to L when driving on rough terrain, or to H when driving on smooth terrain.

Latch

Battery compartment

Jeep Wrangler Transmitter

Jeep Antenna Tube AA Battery Tray

User’s Guide

Safety and Care

• Do not use your Jeep near transmitters with the same frequency (27 MHz or 49 MHz).

• A nearby CB can interfere with your Jeep’s control. If this happens, move the Jeep away from the CB.

• Never play with your Jeep in the street.

• Avoid high-impact collisions with people and objects.

RF Emissions Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult your local RadioShack store or an experienced technician for help.

If you cannot eliminate the interference, the FCC requires that you stop using your Jeep. Changes or modiﬁcations not expressly approved by RadioShack may cause interference and void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Charge a 9.6 V battery pack (not supplied) before installing.

1. Turn off your Jeep and transmitter.

2. Insert one 9V battery (not supplied) in the transmitter battery compartment matching the polarity symbols (+ and -) marked inside.

3. Load and connect a fully-charged 9.6V battery pack or battery tray with 6 AA batteries (neither supplied). The connector ﬁts only one way. Do not force it.

4. Replace the battery door and secure the latch.

Battery Notes:

• Use only fresh batteries of the required size and recommended type. Use batteries of the same types, capacities and chemistries.

• Do not burn or bury batteries.

• To keep motor heat levels down, let the Jeep cool at least ten minutes between battery exchanges.

• If you do not plan to use the Jeep for a week or longer, remove the batteries from both the Jeep and transmitter.

• Position the battery connectors and wires so they do not touch any moving parts.

Band ABC

ON/OFF

R / L – Turn toward R if the Jeep pulls to the left, or toward L if it pulls to the right.

Jeep® and the Jeep® grille design are registered trademarks of DaimlerChrysler Company, LLC. Jeep® Wrangler® Unlimited and its trade dress are used under license from DaimlerChrysler. DaimlerChrysler Company, LLC 2007.

Limited 90-day Warranty

This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack companyowned stores and authorized RadioShack franchisees and dealers. For complete warranty details and exclusions, check with your local RadioShack store.

RadioShack Customer Relations

300 RadioShack Circle

Fort Worth, TX 76102 04/04

07A07

60-202

Printed in China