Radio Shack 43-811 User Manual

READ THIS FIRST
We have designed your telephone to conform to federal regulations and you can connect it to most telephone lines. However, each device you connect to the phone line draws power from it. This power draw is the device’s
Ringer Equivalence Number
on the bottom of your phon e. If you are using more than one phone or other device on
the line, add up all the RENs. If the total is m ore than five (or three in rural areas) your phones might not ring. If ringer operation is impaired, remove one of the devices from the line.
If your phone causes problems on the phone line, the telephone company can disconnect your service. The phone company tries to notify you i n advance . If advanc e notice is not practical, the telephone company notifies you as soon as possible and advises you of your right to file a com p laint with the FCC.
The phone company can also make changes to its lines, equipment, operations, or procedures that could affect the phone’s operation. The phone company notifies you in advance, so you can take the necessary steps to pre­vent interruption of your phone service.
, or REN. The REN is shown
FCC STATEMENT
Your telephone complies with Part 68 of must, upon request, provide the FCC registration num­ber and the REN to your telephone company. These numbers are shown on the bott om of your phone.
Note:
You must not connect your telephone to:
• Coin-operated systems
• Party-line systems
• Most electronic key phone systems
FCC Rules
. You
CARE
• Keep the phone dry.
• Handle the phone carefully. Do not drop it.
• Do not use or store the phone in temperature extremes.
• Keep the phone away from dust and dirt.
• Do not modify or tamper wit h the phone’ s int ernal com­ponents. Doing so might invalidate the phone’s war­ranty and void your FCC authorization to operate it. If the phone is not operating as it should, take it to your local RadioShack store for assistance. If the trouble is harming the phone lines, the phone company might ask you to disconnect the telephone until you fix the problem.
RadioShack Limited Warranty
This telephone product is warranted against manufacturing defects in material and workmanship for one (1) year from the date of purchase from RadioShack company owned stores and authorized RadioShack franchisees and dealers. Within this period
bring your RadioShack sales slip
date to any RadioShack store. This w arrant y does n ot cover damag e or fai lure caus ed by or attributable to Acts of God, abuse, misuse, improper or abnor­mal usage, fa ulty ins tallati on, impr oper m aintenanc e, lig htning or other incidence of excess voltage, or any repairs other than those p r ov id ed by a Radi oShack A ut ho r iz ed Service Faci li ty, or transportati on costs.
for indire ct, spe cial , or con seque ntial damage s aris ing out of or in connection with the use or performance of the product or oth er damage s with r e spect to loss of property, loss of revenue or profit, or costs of removal, installation or reinstallation.
EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPL IED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. Some states do not allow the limitation or exclusion of incidental or consequential damages and some states do not allow limita­tion or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser. There will be charges rendered for repairs to the product made after the expiration of the aforesaid one (1) year warranty period.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
A Division of Tandy Corporation
7A6 Printed in China
RadioSha ck is no t r esponsible or l iab le
We Service What We Sell
RadioShack
Fort Worth, Texas 76102
as proof-of-purchase
10/95
Krystalite
Neon Phone
n Neon Light
n Tone or Pulse (Rotary) Dialing
nRedial
n Flash
nRinger Switch
n Hold Button with Indicator
Owner’s Manual
Cat. No. 43-811
CONNECTING THE PHONE
USING THE PHONE
Route supplied ada pter through strain-r elief slot.
Note:
The adapter powers the light.
Cautions:
• Al ways unplug the adapter from the AC outlet before you unplug the other end from the phone.
• You must use an adapter that supplies 12V and deliv­ers at least 500 mA. Its center tip must be set to posi­tive, and its plug must correctly fit the phone’s jack. Using an adapter that does not meet these spec­ifications could seriously damage the phone or adapter.
DC 12V
Switch to the type of service you have.
If you have pulse (rotary) service, you can switch to call to use tone serv ices.
Yo u can set
LOW
•HI for a bright glow.
Notes
• Regardless of the lamp switch setting, the neon light
• It is normal for your new neon lamp to occasionally
for a di m gl ow.
OFF
to turn off the neon light.
:
turns off when you pick up the handset, and flashes when the phone rings.
flicker when you first use it. If it flickers, set
LOW/H I/OFF
HI
to
or
should steady th e lamp’s glow.
or
TONE
LOW
PULSE
LAMP/L OW/HI /OFF
OFF
to
to turn the neon lamp on again. This
to match
during a
TONE
to:
for 1 minute, then set the switch
Press
REDIAL
ber dialed (up to 31 digits).
Note:
The redial memory does not store a you press after
to dial the last num-
entry or any keys
FLASH
FLASH
LAMP/
.
RINGER ON/OFF
Set have the ringer sound when you receiv e a call or to the ringer. You can still make calls with the ringer off, and you can receive calls if you hear another phone on the same line ring.
Press switchhook signal for special ser­vices such as call waiting.
Note:
If you do not subscribe to
any special services, pressing
FLASH
to produce a timed
FLASH
might disconnect the call.
to ON to
OFF
to silence
Note:
The phone company charges to install any neces­sary jacks. The USOC number of the jack to be installed is RJ1 1C .
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol is intended to inform you that parts inside the telephone present a risk of electric shock.
This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.
Plug the handset cord into the jacks on the handset and base.
Press without disconnecting the call. To release a call from hold, lift the handset or press and hold the switchhook for 1 second.
Note:
release a call from hold.
1996 Tandy Corporation.
RadioShack is a trademark used by Tandy Corporation.
All Rights Reserved.
ÐÐ
Press to disconne ct a call.
The indicator lights when a call is on hold .
HOLD
to hang up the handset
Do not press
FLASH
to
Loading...