SST-4035E
OPERATING DOOR.
EDGE OF THE SIDE JAMB OF THE
-- MOUNTING OF PHOTO BAR --
SHOULD BE LINED UP WITH THE OUTSIDE
THE OUTSIDE EDGE OF THE EYE-BAR
BE SUPPLIED BY OTHERS
ANCHOR SCREWS TO
EYE WIRE
IN BX CABLE
115V- POWER SUPPLY
CAUTION: POWER SUPPLY IS LOCATED
DRILL THRU CENTER WITH CAUTION
IN LEFT-HAND JAMB - PLEASE
EYE WIRE
(SUPPLIED BY
CONTRACTOR)
JUNCTION BOX
FIG. C
FIG. A
FIG. B
EYE BAR
110 Volt Power Source
Eye Wire Cable
Eye Set to Be Mounted In Middle Of Service Opening
Drawing Name: Scale:
Rev.Drawn By:
Quikserv Corp.
1-800-388-8307
www.quikserv.com
Date:
SST-4035E Installation Drawing
10/15/2014
BC
N/A
SST-4035E Installation Drawing
Rough Opening:
Actual Dimension:
Service Opening:
NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL
RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO
OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.
48-3/8" (W) X 52-3/8" (H)
48" (W) X 52" (H)
20-3/4" (W) X 29" (H)
BY CERTIFIED ENGINEER.
(SEE FIG. D)
WINDOW ON THE WALL. (SEE FIG. C)
APPROX. 5" AT TOP & BOTTOM OF EACH JAMB.
3) ANCHOR THROUGH EACH SIDE JAMB AT TWO PLACES
9) ALL OTHER TYPE OF ANCHORING TO BE APPROVED
TO BE 36". (CHECK ANY AND ALL LOCAL OR CITY CODES)
7) RECOMMENDED HEIGHT FROM FLOOR TO SERVICE OPENING
5) ALL PHOTO EYE BARS SHOULD BE MOUNTED BELOW
2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.
SQUARE TO WORK PROPERLY.
1) QUIKSERV WINDOWS MUST BE INSTALLED LEVEL AND
TYPICAL
SST-4035E INSTALLATION
8) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.
4) CAUTION WHEN DRILLING-POWER SUPPLY AND EYE
WIRE LOCATED IN LEFT SIDE JAMB. (SEE FIG. A)
6) 115V/15AMP DEDICATED CIRCUIT REQUIRED.
Loading...