Quikserv QST-619-DT Installation Manual

Drawing Name: Scale:

Rev.Drawn By:

Quikserv Corp.

1-800-388-8307
www.quikserv.com

Date:

QST-619 & 619S Installation Drawing

1/28/2015

BC

N/A

QST-619-DT & 619S Installation

Rough Opening:

Actual Dimension: QST-619S

NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL

RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO

OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.

21-1/8" (W) X 6-5/8" (H)

20-3/4" (W) X 6-1/4" (H)

BY CERTIFIED ENGINEER.

INTERIOR SIDE TO THE EXTERIOR.

3) SLIDE DRAWER THROUGH ROUGH OPENING FROM THE

10) ALL OTHER TYPE OF ANCHORING TO BE APPROVED

NO MORE THAN 4-1/2" FOR MAXIMUM TRANSFER AREA. (SEE FIG. C)

7) MAXIUM MULLION WIDTH (DEPTH) ABOVE DRAWER TO BE

5) SLIDE DRAWER FLUSH WITH EXTERIOR WALL.

2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.

SQUARE TO WORK PROPERLY.

1) QUIKSERV DRAWERS MUST BE INSTALLED LEVEL AND

TYPICAL

QST-619 & 619S INSTALLATION

9) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.

4) ATTACH FLANGE TO OUTSIDE OF DRAWER USING THE
THE 4 SCREWS SUPPLIED TO THE PRE- TAPPED HOLES

6) ANCHOR BOTTOM OF DRAWER TO COUNTER TOP OR SHELF.

ON THE SIDE OF DRAWER. (SEE FIG. A)

(SEE FIG. B & D)

8) BACK PANEL OF DRAWER MUST BE ACCESSIBLE TO
SERVICE DRAWER.

QST-619S

Rough Opening:

15-1/4" (W) X 6-5/8" (H)

QST-619

Actual Dimension: QST-619

14-7/8" (W) X 6-1/4" (H)