Quikserv QSP-713 Installation Manual

Drawing Name: Scale:

Rev.Drawn By:

Quikserv Corp.

1-800-388-8307
www.quikserv.com

Date:

QSP-713E Installation Drawing

10/16/2014

BC

N/A

QSP-713 Electric Installation Drawing

Rough Opening:

Actual Dimension:

NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL

RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO

OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.

28-1/2" (W) X 11-1/2" (H)

BY CERTIFIED ENGINEER.

INTERIOR SIDE TO THE EXTERIOR.

3) SLIDE DRAWER THROUGH ROUGH OPENING FROM THE

11) ALL OTHER TYPE OF ANCHORING TO BE APPROVED

NO MORE THAN 8" FOR MAXIMUM TRANSFER AREA. (SEE FIG. C)

8) MAXIUM MULLION WIDTH (DEPTH) ABOVE DRAWER TO BE

5) SLIDE DRAWER FLUSH WITH EXTERIOR WALL.

2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.

SQUARE TO WORK PROPERLY.

1) QUIKSERV DRAWERS MUST BE INSTALLED LEVEL AND

TYPICAL

QSP-713E INSTALLATION

10) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.

4) ATTACH FLANGE TO OUTSIDE OF DRAWER USING THE
THE 4 SCREWS SUPPLIED TO THE PRE- TAPPED HOLES

6) ANCHOR BOTTOM OF DRAWER TO COUNTER TOP OR SHELF.

ON THE SIDE OF DRAWER. (SEE FIG. A)

(SEE FIG. B & D)

9) BACK PANEL OF DRAWER MUST BE ACCESSIBLE TO
SERVICE DRAWER.

28-7/8" (W) X 11-7/8" (H)

Transfer Area:

13" (W) X 6-1/2" (H) X 19" (D)

USE THE 2 SUPPORT BRACKETS SUPPIED. DO NOT DRILL

7) IF MOUNTING INTO CABINETRY OR FLUSH WITH COUNTER

THROUGH INTERIOR DRAWER WALL. USE NO LARGER
THAN 1/2" SCREWS. (SEE FIG. E & F)

1