Page 1
Drawing Name: Scale:
Rev.Drawn By:
Quikserv Corp.
1-800-388-8307
www.quikserv.com
Date:
QSB-12 & 12S Installation Drawing
10/16/2014
BC
N/A
QSB-12 & QSB-12S Installation
Rough Opening:
Actual Dimension: QSB-12S
NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL
RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO
OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.
28-3/8" (W) X 15-7/8" (H)
28" (W) X 15-1/2" (H)
BY CERTIFIED ENGINEER.
INTERIOR SIDE TO THE EXTERIOR.
3) SLIDE DRAWER THROUGH ROUGH OPENING FROM THE
10) ALL OTHER TYPE OF ANCHORING TO BE APPROVED
NO MORE THAN 8" FOR MAXIMUM TRANSFER AREA. (SEE FIG. C)
7) MAXIUM MULLION WIDTH (DEPTH) ABOVE DRAWER TO BE
5) SLIDE DRAWER FLUSH WITH EXTERIOR WALL.
2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.
SQUARE TO WORK PROPERLY.
1) QUIKSERV DRAWERS MUST BE INSTALLED LEVEL AND
TYPICAL
QSB12 & QSB12S INSTALLATION
9) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.
4) ATTACH FLANGE TO OUTSIDE OF DRAWER USING THE
THE 4 SCREWS SUPPLIED TO THE PRE- TAPPED HOLES
6) ANCHOR BOTTOM OF DRAWER TO COUNTER TOP OR SHELF.
ON THE SIDE OF DRAWER. (SEE FIG. A)
(SEE FIG. B & D)
8) RIGHT SIDE OF BACK PANEL AND ALSO THE BACK OF DRAWER
MUST BE ACCESSIBLE TO SERVICE DRAWER.
QSB-12S
Rough Opening:
18-3/8" (W) X 15-7/8" (H)
QSB-12
Actual Dimension: QSB-12
18" (W) X 15-1/2" (H)
Loading...