Quikserv PW-54E Installation Manual
IN LEFT-HAND JAMB - PLEASE
DRILL THRU CENTER WITH CAUTION
CAUTION: POWER SUPPLY IS LOCATED
CAUTION: POWER SUPPLY IS LOCATED
DRILL THRU CENTER WITH CAUTION
IN LEFT-HAND JAMB - PLEASE
TOP VIEW
( SUPPLIED BY OTHERS )
SUB-FRAME AND
=" WHEN NEEDED"=
SNAP-IN FACE
CATION; EYE WIRE
EYE WIRE
WITH SNAP IN COVER SUPPLIED
1 3/4" OPEN BACK SUB-FRAME
POWER SUPPLY IS PULLED FROM
115V/15AMP DEDICATED CIRCUIT
HARDWARE BY OTHERS -
BOTTOM LEFT-HAND JAMB.
BY OTHERS
BY OTHERS
TO BE SUPPLIED
ANCHOR SCREWS
FIG. A
FIG. B
FIG. D
FINISH WALL
GLASS MUST
FROM
8"
EXTERIOR
WALL.
FINISHED
BY THE
OBSCURED
NOT BE
SASH AND
SIDE VIEW
Drawing Name: Scale:
Rev.Drawn By:
Quikserv Corp.
1-800-388-8307
www.quikserv.com
Date:
PW-54E Installation Drawing
9/25/2014
BC
N/A
PW-54E Installation Drawing
Rough Opening:
Actual Dimension:
Service Opening:
NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL
RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO
OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.
54" (W) X 40-1/2" (H)
53-1/2" (W) X 40" (H)
18-1/4" (W) X 31-1/2" (H)
BY CERTIFIED ENGINEER.
(SEE FIG. D)
LOCATED IN RIGHT SIDE JAMB. (SEE FIG. B)
APPROX. 5" AT TOP & BOTTOM OF EACH JAMB.
3) ANCHOR THROUGH EACH SIDE JAMB AT TWO PLACES
9) ALL OTHER TYPE OF ANCHORING TO BE APPROVED
TO BE 36". (CHECK ANY AND ALL LOCAL OR CITY CODES)
7) RECOMMENDED HEIGHT FROM FLOOR TO SERVICE OPENING
5) CAUTION WHEN DRILLING - EYE WIRE CABLE
2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.
SQUARE TO WORK PROPERLY.
1) QUIKSERV WINDOWS MUST BE INSTALLED LEVEL AND
TYPICAL
PW-54E INSTALLATION
8) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.
4) CAUTION WHEN DRILLING-115V POWER SUPPLY
WIRE LOCATED IN LEFT SIDE JAMB. (SEE FIG. A)
6) 115V/15AMP DEDICATED CIRCUIT REQUIRED.
Loading...