Quikserv PW-3 Installation Manual
ALL THREAD ROD
SIDE VIEW
32"
8"
SUB-FRAME
4"
ALL THREAD ROD
FIG. A
DRILLING THRU SIDE JAMBS SHOULD
BE OFF CENTER TO AVOID ALL THREAD
ROD IF NOT USING SUB-FRAME.
TOP VIEW
NOTE:
WITH SNAP IN COVER SUPPLIED BY
1-3/4"X 4" OPEN BACK SUB-FRAME
INTERIOR WALL
BE SUPPLIED BY OTHERS
ANCHOR SCREWS TO
OTHERS
WINDOW UNIT
1-3/4" X 4"
FRAME
FIG. B
Drawing Name: Scale:
Rev.Drawn By:
Quikserv Corp.
P.O. Box 40466
Houston TX 77240
1-800-388-8307
www.quikserv.com
Date:
PW-3 & 4 INSTALLATION
12/3/2009
BC
N/A
PW-3 & 4 Installation Drawing
Rough Opening:
Actual Dimension:
Service Opening:
28-1/8" (W) X 40-3/8" (H)
27-3/4" (W) X 40" (H)
PW-4 14" (W) X 24-1/4" (H)
NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL
RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO
OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.
1) QUIKSERV WINDOWS MUST BE INSTALLED LEVEL
AND SQUARE TO WORK PROPERLY.
2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.
4) ANCHOR THROUGH EACH SUB-FRAME AT TWO PLACES
APROX. 5" AT TOP AND BOTTOM OF EACH SIDE JAMB.
SEE FIG. B
5) IF NOT USING SUB-FRAME USE CAUTION WHEN
DRILLING THRU EACH SIDE JAMB AS ALL THREAD
RODS ARE LOCATED IN EACH SIDE JAMB. SEE FIG. A
6) RECOMMENDED HEIGHT FROM FLOOR TO SERVICE
OPENING TO BE 36". (CHECK ALL LOCAL AND CITY
CODES.)
7) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.
8) ALL OTHER TYPE OF ANCHORING TO BE APPROVED
BY CERTIFIED ENGINEER.
TYPICAL
PW-3 & 4 INSTALLATION
3) INSTALL A 3 SIDED OPEN BACK SUB-FRAME
1-3/4" X 4" (SUPPLIED BY OTHERS.)
SEE FIG. A
PW-3 14" (W) X 18-1/4" (H)
Loading...