Quikserv CM-1 Installation Manual

ALL THREAD ROD

Drawing Name: Scale:

Rev.Drawn By:

Quikserv Corp.

P.O. Box 40466
Houston TX 77240

1-800-388-8307
www.quikserv.com

Date:

CM-1 INSTALLATION

12/3/2009

BC

N/A

CM-1 Installation Drawing

Rough Opening:

Actual Dimension:

Service Opening:

24-3/8" (W) X 38-7/8" (H)

24" (W) X 38-1/2" (H)

16" (W) X 32" (H)

NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL

RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO

OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.

1) QUIKSERV WINDOWS MUST BE INSTALLED LEVEL
AND SQUARE TO WORK PROPERLY.

2) ANHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.

3) ANCHOR THROUGH EACH SIDE AT TWO PLACES
APROX. 5" AT TOP AND BOTTOM OF EACH SIDE JAMB.
SEE FIG. B

4) CAUTION WHEN DRILLING THRU SIDE JAMBS - ALL
THREAD RODS ARE LOCATED IN EACH SIDE JAMB.
SEE FIG. A

5) RECOMMENDED HEIGHT FROM FLOOR TO SERVICE
OPENING TO BE 36". (CHECK ALL LOCAL AND CITY
CODES.)

6) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.

7) ALL OTHER TYPE OF ANCHORING TO BE APPROVED
BY CERTIFIED ENGINEER.

TYPICAL

CM-1 INSTALLATION