Quikserv BP-4841E Installation Manual

FIG. A

CONTRACTOR)

(SUPPLIED BY

JUNCTION BOX

TOP VIEW

FIG. B

115V- POWER SUPPLY

EYE WIRE

BY OTHERS

TO BE SUPPLIED

ANCHOR SCREWS

EYE WIRE
IN BX CABLE

CAUTION: POWER SUPPLY IS LOCATED

DRILL THRU CENTER WITH CAUTION

IN LEFT-HAND JAMB - PLEASE

-- MOUNTING OF PHOTO BAR --

THE MIDDLE OF THE OPERATING DOORS

THE EYE-BAR SHOULD LINED UP IN

FIG. C

FIG. D

EXTERIOR VIEW SHOWN

Drawing Name: Scale:

Rev.Drawn By:

Quikserv Corp.

P.O. Box 40466
Houston TX 77240

1-800-388-8307
www.quikserv.com

Date:

BP-4841E Installation Drawing

12/10/2009

BC

N/A

BP-4841E Installation Drawing

Rough Opening:

Actual Dimension:

Service Opening:

NOTE:THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY QUIKSERV CORP., AND IS SUBMITTED UNDER A CONFIDENTIAL

RELATIONSHIP. ALL PATENT, MANUFACTURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO

OTHERS. THE RECIPIENT AGREES BY ACCEPTING THESE DRAWINGS NOT TO SUPPLY OR DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.

48-3/8" (W) X 41-3/8" (H)

48" (W) X 41" (H)

17" (W) X 29" (H)

BY CERTIFIED ENGINEER.

(SEE FIG. D)

(SEE FIG. C)

APPROX. 5" AT TOP & BOTTOM OF EACH JAMB.

3) ANCHOR THROUGH EACH SIDE JAMB AT TWO PLACES

9) ALL OTHER TYPE OF ANCHORING TO BE APPROVED

TO BE 36". (CHECK ANY AND ALL LOCAL OR CITY CODES)

7) RECOMMENDED HEIGHT FROM FLOOR TO SERVICE OPENING

5) ALL PHOTO EYE BARS SHOULD BE MOUNTED AS SHOWN.

2) ANCHOR SCREWS TO BE SUPPLIED BY CONTRACTOR.

SQUARE TO WORK PROPERLY.

1) QUIKSERV WINDOWS MUST BE INSTALLED LEVEL AND

TYPICAL

BP-4841E INSTALLATION

8) SILICONE ALL EXTERIOR AND INTERIOR JOINTS.

4) CAUTION WHEN DRILLING-POWER SUPPLY AND EYE
WIRE LOCATED IN LEFT SIDE JAMB. (SEE FIG. A)

6) 115V/15AMP DEDICATED CIRCUIT REQUIRED.