Quikserv 1580 Installation Manual

QUIKSERV AUDIO INSTALLATION 1580

QUIKSERV AUDIO INSTALLATION 1580

QUIKSERV AUDIO INSTALLATION 1580QUIKSERV AUDIO INSTALLATION 1580

The 1580’s kit consists of one model 1580, one model 1583, and a 571-013 power supply.

To complete the system, the necessary lane station, speakers, call buttons and microphone
will be already installed in the QuikServ drawer (see list below).

QST-713E – All wiring will be in left front speaker housing (inside view).

QST-713S – Wiring in both speakers housing.

QSB-12 – Wiring in both speakers housing.

QST-1019S – Wiring in speaker housing.

QST-619S – Wiring in speaker housing.

QST-625S – Wiring in speaker housing.

See AA1580 Wiring Diagram Fig 1.

Fig 1 shows the typical wiring method.

1. After plugging in the main components as shown (the 1580 counter station and the
1583 lane station using a cat 5 cable).

2. Wire each lane port of the 1583 dual lane station to its respective microphone,
speaker and call button using shielded, paired cable. 18-AWG – three – pair cable is
sufficient for two-way audio and call functions.

3. Mount the 1583 on the wall or under the counter, or in some other nearby location.

4. Plug in AC power supply to 1583 and to a nearby 110 volt outlet.

5. If using Model 1547 lane sensors:

a. The 1583 dual lane sensors provide a connection for AA1547 traffic sensors.

One or two 1547 sensors may be connected to the 1583 flash port, located
on the end panel, via the 1549 adapter as shown.

b. When vehicle triggers the 1547, the counter station generates a call tone for

the corresponding lane to alert the operator.

6. Wiring Notes: Whatever cable is used, it must have an overall foi
wire is connected to the common (#8) terminal on each lane station block. The drain
wire on the customer end of the cable must be cut off and not connected

wire on the customer end of the cable must be cut off and not connected.... For proper

wire on the customer end of the cable must be cut off and not connectedwire on the customer end of the cable must be cut off and not connected
system operation, one of the lane common terminals must also be connected to a
good ground, such as an electrical box or a metallic structural main bar, using green
ground wire supplied. This wire may be extended if necessary.

overall foil shield

overall foioverall foi

l shield – the drain

l shieldl shield

The drain

The drain The drain