QuickLabel QuickPeel User Manual

QuickPeel Alignment Guide

12.28.2006 Part Number 22834543

Overview

This document provides information about aligning the QuickPeel system components.

QuickPeel System with Slitter

QUICKPEEL
ALIGNMENT BAR

MAGNET

REWINDER
42670-610

QUICKPEEL
ALIGNMENT BAR
14510-001

LABEL SLITTER
26541-100

MAGNET

QUICKPEEL
ALIGNMENT BAR
14510-001

MAGNET

DUAL REWINDER
42670-020

Note: QuickPeel Alignment Bar shown twice in order to demonstrate position. In reality, one
QuickPeel Alignment Bar will be used twice.

QuickPeel Alignment Procedure

1. Begin by using the QuickPeel Alignment Bar to align the Dual Rewinder to the Label Slitter.

MAGNET

MAGNET

2. Place a magnet at the right edge of the Dual Rewinder base. Place another along the front
face of the Label Slitter. The Alignment Bar will then be placed on top of these magnets.

3. The rear tab should be square to the right side face of the Dual Rewinder.

4. The front face of the Alignment Bar should be parallel to the front face of the Rewinder.

5. The right side face of the indentation should be square to the right edge of the Slitter.

6. The front face of the indentation should be parallel to the front face of the Slitter.

MAGNET

MAGNET

7. Flip the Alignment Bar over and align the Label Slitter to the Rewinder.

8. Place a magnet at the left edge of the Rewinder base. Place another along the front face of the
Label Slitter. The Alignment Bar will then be placed on top of these magnets.

9. The rear tab of the Alignment Bar should be square to the left side face of the Rewinder.

10. The front face of the Alignment Bar should be parallel to the front face of the Rewinder.

11. The left side face of the indentation should be square to the left edge of the Slitter.