OUTPUT ISOLATION TRANSFORMER
COM
IT-42
CH 1
CH 2
70V
100V
100V
70V
COM
The IT-42 is an output isolation transformer accessory for the
QSC CX302 amplifier, allowing it to drive two 25-, 70- and
100-volt distributed lines in stereo or parallel or a single 140-
or 200-volt line in bridged mono. The IT-42 is pre wired for
quick and convenient mounting to the back of the CX302
amplifier and requires no additional rack space.
Output Voltage
25V
70V
100V
140V
200V
Maximum Distributed
Line Power, Midband
300W x2
400W x2
400W x2
(Bridged Mono)
800W
(Bridged Mono)
800W
Specifications
• Fully isolated secondary
• Dual channel: 25V, 70V, or 100V lines
• Bridged mono: 140V or 200V line
• Up to 400 watts per channel or 800 watts
in bridged mono
• Frequency response: 75 Hz–12 kHz +0, -3 dB,
loaded with 12.2 ohms (70V) or 25 ohms (100V)
non-inductive load. (using 75 Hz filter on amplifier)
• Output regulation: < 1 dB at midband
frequencies, no-load to full-load (3 dB for 25V loads)
• Weight 3.6 pounds (1.6 kg)
• Overall depth (amplifier + IT-42) 17.3 inches (440 mm)
• Harmonic distortion: less than 0.05%, 75 Hz, -3 dB
less than 0.5%, 150 Hz–12 kHz at 0 dB
1675 MacArthur Boulevard
Costa Mesa, CA 92626
Ph: 800/854-4079 or 714/957-7100
Fax: 714/754-6174
www.qscaudio.com