Q Acoustics M2 User Manual

1

Qm2

MANUAL

2

3

Important safety information and warnings

Introduction
Package contents
Feature summary
Product description
Use scenarios
Features

Top panel
Front

Rear panel
Remote control
Operating Q Acoustics Unit

On / In / Wall EQ

Power and standby

Intelligent Pre-Amplifier (IPA™)

Auto On / Off

Auto On / Off Times

Auto source select

Low source gain (LSG™)

Source volume control

Bluetooth

®

MoviEQ

™

Lip Sync

Cable / satellite remote control
Specification
Warranty

Contents

4
6
6
7
8
9
10

15
16

20
22
23

4

Important Safety Information and Warnings

1 Notices

1.1 FCC Statement (For US Customers)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

1.2 FCC Radiation Exposure

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 8 in/20cm between the radiator and your body.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

CAUTION! Any changes or modifications made to this device that are not expressly approved by Q Acoustics may void the user’s
authority to operate the equipment.

1.3 Industry Canada Statement (for Canadian Customers)
CAN ICES-3 (B)/NMB-3(B)
The device meets the exemption from the routine evaluation limits set out in section 2.5 of RSS 102 and is in full compliance with
RSS-102 RF. Users can obtain information on RF exposure
and compliance from Industry Canada.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause undesired operation.

1.4 Bluetooth

®

This unit contains a Class 2 Bluetooth® transmitter working at 2.4GHz.

2 Safety Information and Warnings

2.1 Instructions

Read and understand these instructions before you use your Soundbar. If damage is caused by failure to follow these instructions,
the warranty does not apply. Please keep these instructions in a safe place.

Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers that produce
heat.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they
exit from the apparatus.
Only use attachments/accessories specifie by the manufacturer.
Use only with the cart, stand, tripod, bracket, or table specifie by the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualifie service personnel. Servicing is required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.

2.2 Installation

• The mains plug is the means of disconnecting the unit from the mains supply and shall be readily accessible.

• Only use the accessories supplied with the unit.

5

• To prevent injury,this apparatus must be securely attached to the floor/wall in accordance with the installation instructions.

• Never install this product in a confined space. Always leave a space or at least four inches around the product for ventilation.

• The ventilation should not be impeded by covering the ventilation openings with items,such as newspapers,table-cloths,curtains,etc.

• Do not place any sources of danger on the apparatus (for example: liquid filled objects, lighted candles).

• The use of apparatus is in tropical and/or moderate climates.

2.3 Moisture

• To reduce the risk of fire or electric shock, this apparatus should not be exposed to rain, moisture, dripping or splashing.

• Do not use this apparatus near water.

2.4 Remote Control Battery

The remote control supplied with this unit contains a coin/button cell battery. To prevent battery leakage which may result in bodily
injury, property damage, or damage to the unit:

• Install the battery correctly, + and - as marked on the unit.

• Remove the battery when the unit is not used for a long time.

• Do not expose the battery or remote control to excessive heat, including sunshine.

• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

• WARNING - DO NOT INGEST BATTERY - CHEMICAL BURN HAZARD.

• If the battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries
away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you
think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention

Disposal of Batteries

The battery supplied contains perchlorate material and in many areas batteries may not be disposed of with your household waste.
Please ensure you dispose of batteries according to local regulations.

The battery supplied does not contain the heavy metals mercury or cadmium.

2.5 Servicing

Servicing is required when the unit or mains cord has been damaged in any way, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, it does not operate normally, or has been dropped.

Refer all servicing to qualified service personnel.

3.0 Symbols used on this product

Class II Equipment Symbol

High Voltage Hazard Symbol

Hazard Warning Symbol

Waste Electrical and Electronic
Equipment Symbol

This symbol indicates that the unit has a Class II double insulation system,
and no protective earth provided.

This symbol indicates uninsulated material within your unit may cause an
electrical shock. For the safety of everyone in your household, please do
not remove the product covering.

The ‘exclamation mark’ calls attention to features for which you should
read this manual closely to prevent operation and maintenance problems.
WARNING: To reduce the risk of fire or electric shock, this apparatus
should not exposed to rain or moisture and object filled with liquids, such
as vases, should not be placed on this apparatus.
CAUTION: To prevent electric shock, match wide blade of plug to wide
slot, fully insert.

This symbol indicates that when the unit is to be discarded, it must
be separated from other household-type waste and sent to separate
collection facilities for recovery and recycling of electrical and electronic
equipment.

Please make sure you are familiar with your local rules on the separate
collection of electrical and electronic products.

6

Thank you for purchasing Q Acoustics.

This manual is intended to take you through the setup and installation of the M2. It will help provide a trouble
free setup and optimum performance from the product.

Please read the instructions, important safety information and warnings carefully before installation and use,
to ensure the safe and satisfactory operation of this product.

We hope you enjoy the Q Acoustics experience.

Introduction

Package Content

SOURCE

EQ

QUICK START GUIDE QUICK START GUIDE

WARRANTY

1 x Q m2 Soundbar

1 x Remote Control

1 x Quick Start Guide 1 x SAFETY

INFORMATION

1 x Warranty Card

1 x Mains Cable

(Regional mains cable)

1 x HDMI Cable

7

IPA™ – Q Acoustic’s Intelligent Pre-Amplifier removes the need for a remote control through a

signal sensing matrix to enable auto source selection and auto on/off.

MoviEQ™ – Q Acoustic’s Movie EQ helps to maximise the drama and excitement of a movie or

TV soundtrack. Toggle it on or off for music and movie settings.

NFC – Near Field Connection allows simple connection of Bluetooth® devices by tapping the
NFC location on the Q Acoustics speaker.

HDMI ARC – High Definition Multimedia Interface Audio Return Channel removes the need for
additional Optical or Analogue audio cables between source and speaker.

CEC – Consumer Electronics Control syncronises TV remote control of Volume, Mute and
Standby for easy integration of our Q Acoustics speaker.

Bluetooth® – An international wireless connection used for streaming audio from all compatible

devices.

aptX™ – A high definition audio CODEC used for Bluetooth® streaming.

AVRCP – A Bluetooth control protocol that synchronises your device control of Volume and

Mute for easy integration of our Q Acoustics speaker.

DAC – Digital to Analogue Converter which determines the bit depth and sample rate of the Q
Acoustics speaker; the higher the number, the better the audio quality.

BMR – Balanced Mode Radiators are Q Acoustics mid/high driver of choice, they have a flat
radiating surface which enables their dispersion to fill a room with sound.

DVC – Dual Voice Coil subwoofers are Q Acoustics subwoofer driver of choice, it has two voice
coils in one driver for greater flexibility of design and improved bass control.

Sub Out – A Phono subwoofer output for connection to an external subwoofer. On some of
our older products the additional sub out provides a huge bottom end when used with a Q
Acoustics subwoofer.

Dynamic Bass – Improved response, loudness, depth and control of bass frequencies is
achieved through our dynamic bass enhancement system, to perfectly integrate our inbuilt
DVC subwoofer.

User EQ – User control of EQ setting for best acoustic performance. This can be changed
dependent upon speaker position, mounting, or user preference.

LSG™ –Q Acoustic’s Low Source Gain switch increases the incoming signal level to get

maximum performance from your system when connected to low output signal equipment via
HDMI or Optical.

Power Rating – Total continuous power rating of the system in Watts. Eg. BT3 = 2 x 50W =
100W.

Lip Sync – Adjustable delay for lip synchronisation between TV/screen and Q Acoustics
speaker.

3.5mm – 3.5mm jack socket for Analogue input.

RCA – Stereo phono socket for Analogue input.

Feature summary

8

The Qm2 is simplicity redefined; where beautifully engineered sound meets beautiful design.

This is an elegantly compact soundbar with a big heart to fill your living room without the clutter of a full Hi-Fi
system or even a soundbar with a large external subwoofer.

Q Acoustic’s new Intelligent Pre-Amplifier (IPA™) is designed to seamlessly integrate into your home setup.
The Qm2 is a true plug and play soundbar. Connect it to your television using the ARC HDMI input and
forget about it. The Qm2 becomes one with your TV, leaving you to discover both sides of this unique
product, Music and Movies.

Turn on the Qm2 and Music mode is enabled by default. Our built in aptX® Bluetooth® wireless input
frees the world of music at your fingertips to fill your home with superbly detailed and dynamic audio
reproduction. Discover subtle layers in your music that have been left previously unheard and enjoy music
as was intended!
Switch on the TV and the Qm2 automatically brings clarity of speech and a depth of soundscape that
transforms your TV sound… and when you engage the MoviEQ™ your home will rumble with powerful bass
and dynamics for that full blooded movie experience!

Product description