Page 1
OPERATING
INSTRUCTIONS
Lettuce Witch
Model No. 912-C
TABLE OF CONTENTS PAGE
Installation..................................................................... 2
Operating ....................................................................... 2
Cleaning ........................................................................ 3
Maintenance ................................................................. 3
Parts List....................................................................... 4
LIMITED WARRANTY
This Product is warranted to be free from defects in
material and / or workmanship for a period of (2) years
from date of original installation not to exceed 30
months from date of shipment from our factory, with
the exception of blades. Blades are warranted to be
free from defects at time of delivery only.
Any component which proves to be faulty in material
and/or workmanship will be replaced or repaired (at
the option of Prince Castle, Inc.) without cost to the
customer for parts or labor.
Get all the bite size lettuce you need with Prince
Castle’s fast, and easy Lettuce Witch. Cuts a
whole carton of lettuce in just minutes with no
bruising or tearing. Designed for use in commercial
kitchens, this slicer features precision stainless
steel cutting blades, and durable cast aluminum
construction for long reliable service.
SPECIFICATION
912-C ( 1” square cut) Dimensions
Width 135/8 ” (34.6 cm)
Depth 181/4 ” (43.3 cm)
Height 30” (76.2 cm)
Shipping Weight 30lbs. (13.6 kg.)
This warranty is subject to the following exceptions/
conditions:
z Use of any non-genuine Prince Castle parts
voids this warranty. All genuine Prince Castle
replacement spare parts are warranted for ninety
(90) days from date of purchase.
z This equipment is portable; charges for on
location service (e.g., trip charges, mileage)
are not included in the provisions of this warranty.
z Damage caused by carelessness, neglect, and/
or abuse (e.g., dropping, tampering or altering
parts), equipment damaged in shipment, by fire,
flood or an act of God is not covered under this
warranty.
Printed in March 1999
Prince Castle Inc.
355 East Kehoe Blvd. z Carol Stream, IL 60188
Tel: (630) 462-8800 z Fax: (630) 462-1460
Toll Free: 1-800-PCASTLE
912-511
Page 2
INSTALLATION
1. After you have removed the Lettuce Witch from
the carton, inspect the unit for signs of damage. If
there is damage to the unit:
z Notify carrier within 24 hours after delivery.
z Save carton and packing materials for inspection
purposes.
z Contact your Prince Castle Dealer for replace-
ment or the Prince Castle Customer Sales
Department at 1-800-722-7853 if purchased
directly.
2. Verify that all parts have been received.
CAUTION: Blades are extremely sharp.
3. Attach the four legs to the main frame using the (4)
1
/4-20 screws provided.
figure 1
figure 3
LOCKING LATCH
3. With handle in upright position place lettuce on top of
blades with the core side down.
figure 4
PLACE
LETTUCE
HERE
APPLY ONE DROP OF
PROVIDED ADHESIVE TO
EACH LEG RETAINING SCREW
PRIOR TO INSTALLATION.
4. Attach handle to hole located on the left side of
the frame.
figure 2
HANDLE
OPERATION
4. Grasp the rear handle with your left hand. Using your
right hand, quickly lower the pusher head with one
firm, rapid stroke.
figure 5
REAR
HANDLE
1. Remove core prior to cutting.
2. Release locking latch which holds handle in up
position. See figure 3.
2
Page 3
MAINTENANCE TIPS
2. Loosen the (4) screws which hold the blade cover to
the blade frame. Remove frame and carefully lift the
blade set out.
1. Lubricate guide rods daily.
2. Check blades for damage daily before use.
figure 6
BLADES
BLADE
FRAME
GUIDE
RODS
3. Bent, nicked or dull blade sets must be replaced
immediately. See parts list for correct number.
CAUTION: Blades are very sharp.
figure 8
PUSHER
HEAD
BLADE
COVER
BLADE
FRAME
CLEANING
1. Lift the pusher head handle to upright position, and
flip the locking latch. This locks the handle into the
upright position.
figure 7
PUSHER
HEAD
HANDLE
LOCKING
LATCH
3. Immerse blades and unit into hot soapy water. (Use
a cleaning spray if available.)
4. Rinse thoroughly.
5. Use the pot cleaning brush provided to clean blades
from the reverse side.
6. Let air dry.
3
Page 4
EXPLODED VIEW
PARTS LIST
ITEM PART NO. DESCRIPTION
1 912-9 Guide Rod
2 912-135 Pusher Head
3 76-445 Screw
4 912-151 Blade Cover
5 76-602 Set Screw
6 912-133 Leg
7 912-148 Shoulder Screw
8 912-156 Replacement Blades
9 912-153 Blade Frame
10 76-311 Bolt
ITEM PART NO. DESCRIPTION
11 911-25 Rear Handle
12 912-131 Frame
13 89-959S Rubber Foot (Pkg. of 4)
14 912-137 Arm
15 912-144 Locking Latch
16 912-145 Pivot Link
17 76-582 Thumb Screw
18 76-190 Head Hex Screw
19 73-029 Acorn Nut (Not Shown)
4
Loading...