Prima PAP400C User Manual

Page 1

Hot Water Super Kettle Model: PAP400

Prior to First Use

Remove all packing materials from the inside and outside of the Super Kettle
BOIL FRESH WATER INSIDE THE SUPER KETTLE ONCE AND DISCARD
THE BOILED WATER BEFORE NORMAL USE. This is the best way to clean away any dust, debris or manufacturing residue, which could affect the taste of the water.

How to Use

Always use the appliance on a heat-resistant, flat surface.
Open the lid by lifting the lid release lever
Fill the Super Kettle with the desired quantity of cold water between the Min. and
Max. level.
Close the lid.
Plug the Super Kettle into the wall socket – the BOIL INDICATOR should light. If
it doesn’t press the ‘REBOIL’ button.
When the water has boiled, the Super kettle will switch to keep hot mode automatically and the KEEP WARM light will illuminate.
From cold it takes approximately 45 minutes to boil 4 litres of water.
There are 3 ways to dispense the hot water depending upon your
preference:
1. Via the manual pump. Hold the cup under the WATER OUTLET and press
the WATER PUMP until the desired amount of water is dispensed.
2. Via the DISPENSER SWITCH. Hold the cup under the WATER OUTLET
and press the dispenser switch. The electric pump will start and dispense the required amount of water
3. Via the CUP SWITCH. Offer the cup up to the WATER DISPENSER and
press the rim of the cup lightly against the switch, The electric pump will
start and dispense the required amount of water If the water level falls below the REFILL LEVEL, refill the kettle and press the REBOIL button. (READ IMPORTANT SAFETY NOTES FIRST)

Cleaning

It is extremely important to remember that cleaning of the Super Kettle can only
be performed when the plug has been removed from the supply.
Never immerse any part of the product into water.
Cleaning should be performed when the product has cooled down.
Always ensure the electrical connections of the product remain absolutely dry.
Clean the Kettle with a damp cloth. Do not use cleaning products, which can
cause health hazard or discoloration of the Kettle.
Ensure the outside and the electrical connection parts of the Kettle are completely dry before using.

De- scaling – IMPORTANT WARRANTY ISSUE

It is VITAL to de-scale the Kettle at regular intervals in order to maintain its looks and efficiency. Limescale build up severely inhibits the performance of concealed element Kettles such as this one. Your warranty does NOT cover faults, which are a result of limescale build-up.
The frequency of de-scaling will depend upon the area in which you live
There are many de-scaling powders and tablets available in supermarkets &
hardware stores. Just follow the instructions on the packet. However, you should bear in mind that most descaling powders or tablets are based on treating a 2­litre kettle. Where one tablet is specified you should use 3 or 4 to allow for the much bigger capacity of the Kettle.
Always rinse thoroughly after descaling.
Important Safety Notes
Always unplug the Kettle in the following situations: -
- Before cleaning
- After use
- Before pouring water
Do not unplug the Kettle by pulling the cable cord.
Never place the Kettle in a tilted position.
When dispensing water, always hold the cup as close to the WATER
DISPENSER as possible. This prevents undue splashing of hot water.
Keep the Kettle out of reach of children.
Improper use of Kettle may result in serious scald.
As there is boiling water inside the Kettle, always ensure the lid is securely
fitted whenever Kettle is turned on or hot water is inside.
Be careful of hot steam when lifting the lid for refilling
Never switch on the Kettle when the water level inside is higher than the
indicated maximum level or lower than the minimum level. Otherwise, this will cause water spillage and damage to the heating element respectively. Though there is a cut-off device if the Kettle overheats, allowing the unit to boil dry will eventually damage the heating element.
Avoid touching the exterior of the Kettle as it will be very hot.
Never place the Kettle on a hot surface.
If the supply cord of this appliance is damaged, it must only be replaced by
Prima.
Page 2
The Prima International PLC. Prima House, Premier Park,
Oulton, Leeds LS26 8ZA. United Kingdom Tel: 0113 251 1500
Page 3
CONNECTION TO THE MAINS SUPPLY
The wires in the mains lead are coloured in accordance with the following code:
BROWN - LIVE (L) BLUE - NEUTRAL (N) GREEN/YELLOW - EARTH (E)
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The BLUE wire is the NEUTRAL and must be connected to the terminal which is marked with the letter N or coloured BLACK
The BROWN wire is the LIVE and must be connected to the terminal, which is marked with the letter L or coloured RED.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked E or coloured GREEN or GREEN/YELLOW.
Always ensure that the cord grip is positioned and securely fastened.
WARNING: THIS APPLIANCE MUST BE EARTHED.
If a 13A (BS1363) fused plug is used it must be fitted with a 13A fuse. If in doubt consult a qualified electrician.
WIRING FOR A 13AMP PLUG
www.prima-international.com
Page 4
~~~~~ Warranty ~~~~~
This product is designed for heating water only.
Anything else will invalidate this warranty.
This product is guaranteed for 12 months from the date of purchase when the appliance is used solely for domestic purposes. For commercial use the product is guaranteed for 90 days from the date of purchase.
The guarantee is valid against mechanical or electrical defects if the product is used in accordance with the instructions and provided that it is not connected to an unsuitable electricity supply or dism antled, interfered with or damaged in any way.
IMPORTANT, P LEASE RETAIN THI S WARRANTY Please ask your retailer to either stamp this warranty or simply attach your store receipt. Keep
this warranty somewhere safe. DO NOT SEND TO PRIMA. This guarantee in no way affects your rights under statutory law.
IF THE PRODUCT MALFUNCTIONS DURING IT’S WARRANTY PERIOD IT MUST BE RETKETTLEED TO THE RETAILER FROM WHOM IT WAS PURCHASED FOR REPLACEMENT. IF YOU BOUGHT THIS PRODUCT VIA MAIL ORDER, PLEASE KEEP ALL THE DOCUMENTATION THAT CAME WHEN THE UNIT WAS DELIVERED.
NAME____________________________________________________________
ADDRESS_________________________________________________________
___________________________________________________________________
PURCHASED FROM_________________________________________________
DATE OF PURCHASE ___________________MODEL_____________________
PLEASE REFER TO THE IMPORTANT WARRANTY ISSUE IN THE SECTION ON
DE-SCALING.
Loading...