Prima LPR9000, LPR9002 Operating And Installation

OPERATING AND INSTALLATION

INSTRUCTIONS OF

BUILT-IN OVEN

LPR9000

Dear Customer,

We aim to produce quality products that exceed your
expectations. Each product is tested to ensure they are of the
highest quality.

Your manual is prepared in order to help you to use your
appliance with confidence and maximum efficiency.

Before you use your new appliance for the first time please
read through this manual to understand the features and
controls of this product. Contact your nearest Authorized
Service Agent for the installation of your product.

1

1- Presentation and size of product
2- Warnings
3- Preparation for installation and use
4- Using the oven
5- Cleaning and Maintenance of your product
6- Service and Transport

page 2
page 3
page 6
page 10
page 17
page 18

CONTENTS

2

PART 1: PRESENTATION AND SIZE OF PRODUCT

LIST OF COMPONENTS :

1- Control panel
2- Handle
3- Oven Door
4- Child Lock
5- Tray
6- Lower Heating Element (behind the plate)
7- Upper Heating Element (behind the plate)

8- Wire Grill
9- Racks
10- Oven Light
11- Turbo Heating Element(behind the plate)
12- Fan (behind the plate)
13- Air Outlet Shutters

3

PART 2: WARNINGS

BEFORE STARTING TO USE THE APPLIANCE, PLEASE TAKE ALL ESSENTIAL
SAFETY MEASURES AND THOROUGHLY READ THE USER MANUAL

This appliance has been designed for domestic use as built-in furniture.

After removing the packaging, make sure to check if there is any damage to the appliance.
If there is any damage, never attempt to use the appliance and immediately contact your
Authorized Service Agent. Dispose of unwanted packaging responsibly, recycling where
possible.

The appliance must be installed and put in operation by an authorised technician under the
conditions provided by the manufacturer in this manual. The manufacturer cannot be held
responsible for any damage that might occur due to faulty installation.

Before connecting your appliance to the mains at home, make sure to check the conformity
of voltage and gas settings, which are specified on the information sticker attached to the
appliance and/or packaging, with the usage conditions available.

Do not operate the oven before it is fully installed.

Be sure that all of its buttons are turned off when the appliance is not in use.

Be sure that the supply cable is not wedged during the installation of the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

Before replacing the oven illuminating light, turn off the power to the appliance.

Switch off the appliance before cleaning, maintenance work etc.

Some parts of the appliance may preserve their heat for a long time; please wait until the
parts have cooled down before touching them.

Do not keep flammable items/substances near the appliance while it is in use.

When operating other electrical devices near the appliance, pay attention that their cables
do not come into contact with heated parts.

Your appliance needs sufficient air circulation while it is operating. Carefully read the part
of this manual, where installation procedures are explained and make sure the relevant
conditions are satisfied.

4

FOR THE EFFICIENCY AND SAFETY OF THE APPLIANCE, WE RECOMMEND THAT

YOU ALWAYS USE ORIGINAL SPARE PARTS AND CALL ONLY AUTHORIZED

SERVICE PERSONNEL SHOULD YOU NEED HELP.

During use the appliance becomes hot. Care should be taken to avoid touching heating
elements inside the oven.

WARNING: Accessible parts may become hot during use. Young children should be
kept away

This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Pay attention to the following when using your appliance.

Be careful to connect your appliance to an earthed power outlet or line.

Do not place the power cord of your appliance near any heated spot. Do not pass it near the
hob. Contact the nearest Authorized Service in the event any damage occurs to the power
cord.

For the models with timers, make sure to adjust the time at first run or in case of a power
failure. Heat and moisture will form in your cooking environment. Throughly ventilate your
kitchen.

When you first run your oven a certain smell will be emanated arising from the insulation
materials and the heater elements. For this reason, before using your oven, run it empty at
maximum temperature for 45 minutes. At the same time you need to property ventilate the
environment in which the oven is installed.

Do not touch the interior and the heater when using the oven part of the appliance as it will
be hot. After switching off the heater, do not touch it with your hand before it is completely
cooled off.

Do not put flammable and combustible materials into the oven.

While the front door is open, do not let children climb on the door or sit on it.

The values indicated on the printed documents found on the product are values obtained in
laboratory environment according to relevant standarts. These values may vary according
to the usage and environment conditions of product.

Your appliance is produced in conformity with the relevant safety instructions relating to
electrical appliances. Maintenance and repair works must be performed only by
Authorized Service technicians trained by the manufacturer installation and repair works,
performed without observing the rules may be dangerous.

The outer surfaces is heated while your appliance is operating. The elements heating the
inner surface of the oven and the steam out are extremely hot. These sections will continue
to preserve their heat for certain while even if the appliance is switched off. Never touch the
hot surfaces. Keep children away.

In order to cook in your oven, the oven function and temperature setting buttons need to be
adjusted and the oven timer, if available, needs to be programmed. Otherwise, the oven
will not operate.

While the oven door or drawer is open, do not place anything on it. You may disturb the
balance of the appliance or break the door.

This appliance is designed for indoor use only. Before installation protect it from adverse
weather conditions.

WARNING: If the surface is cracked, switch off the appliance to avoid the possibility of
electric shock.

Caution: The surface temperature exceeds 95 °C. To avoid a hazard, under bench Access
must be restricted. Refer to the installation instructions.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass
since they can scratch the surface,which may result in shattering of the glass.

Do not use steam cleaners for cleaning the oven.

Once the cooking has been completed, the cooling fan continues to operate until the oven
has cooled down sufficiently.

5