Powerware NetSurge Plus, NetSurge Instruction Manual

NetSurge is a state-of-the-art modular surge protector, that protects your sensitive

equipment from the most severe electrical environment. NetSurge is available

with or without a telephone module for protecting modems, fax machines, and

other telecommunications equipment. The NetSurge protector can be upgraded at

any time with additional telephone, LAN, or CATV modules.

SAVE THESE INSTRUCTIONS

Important Safety, Grounding, and Installation Instructions

Q NetSurge is intended for INDOOR USE ONLY.

Q NetSurge must be connected to a grounded, three-wire, AC outlet.

Q Never install telephone or CATV wiring during a lightning storm.

Q NetSurge should be located away from heat sources, such as heat registers.

Q Avoid the use of extension cords and adapters.

Installation

1. Plug the equipment to be protected into the NetSurge protector receptacles.
Ensure that the total load does not exceed 15A.

2. Plug the NetSurge protector into a grounded, three-wire, AC outlet.

3. Turn on the unit by pressing the large round button once.

4. Verify that the two green indicators are illuminated. See the “Diagnostics”
section if the indicators are not illuminated.

Diagnostics

The NetSurge protector has two indicators that provide diagnostic information:
the Power Fault and Status indicator.

Power Fault

Indicator

Status

Indicator

Condition

Normal Operation

The wall outlet may be incorrectly wired
and/or have a poor ground connection.
Have a qualified electrician check the
outlet wiring.

The circuit breaker (black button on the side
of the NetSurge) may have tripped. if the
circuit breaker is protuding, unplug the
equipment from the unit and reset the circuit
breaker. Ensure that the total load
does not exceed 15.

If the circuit breaker does not reset and the
status indicator remains off, the NetSurge
protector has been damaged by the overload
condition.