Page 1
TECHNICAL NOTE #18 rev. 01
DigiMod IS integration kit
How to transform a DigiMod module to DigiMod IS (integrated solution)
1 Preliminary consideration
This ar ticle is related to the following products:
f DigiMod 1000
f DigiMod 1500
f DigiMod 2000HV
The kit that allows to transform a DigiMod module to DigiMod
IS (integrated solution) is labeled KT000276, and comprehends:
f N°1 Heat Sink
f N° 1 interface (already mounted on Heat Sink)
f N° 1 DSP-C
f N° 1 PowerCon Blue (already mounted on Heat Sink)
f N° 1 PowerCon Grey (already mounted on Heat Sink)
f N° 6 Screws for xing DigiMod module on Heat Sink
3 Procedure
1. Fix the DSP-C on DigiMod SIMM board connector with the
two screws.
FIGURE 2: Installing DSP-C
2. Remove all jumpers located on DigiMod on CN18/CN17
f N° 2 Screws for xing DSP-C board on Heat Sink
f N° 1 Bolt for xing ground wire (on PowerCon connection)
to DigiMod module
2 Tools needed
f Phillips cross-wing screwdriver
FIGURE 1: phillipsscrewdriver.jpg
FIGURE 3: Jumpers to be removed, overview
© 2012 - 2013 Powersoft
powersoft_TN018_DigiModISKit_en_v1.0
FIGURE 4: Jumpers to be removed, detail
Keep This Technical Note For Future Reference
Page 2
FIGURE 8: Jumpers removed
3. Fix the DigiMod module on the heat sink with the six screws.
5. Connect the PowerCon mains on the DigiMod.
FIGURE 7: Connecting the powercon
6. Connect the programming at cables from the interface to
the DSP-C on board.
FIGURE 5: Fixing the module on the heat sink
4. Fix the grounding with a bolt.
FIGURE 6: Fixing the grounding
FIGURE 9: Connecting the at cable
7. The procedure is nished.
2
Page 3
Via Enrico Conti, 5
50018 Scandicci (FI) Italy
Tel: +39 055 735 0230
Fax: +39 055 735 6235
General inquiries: info@powersoft.it
Sales: sales@powersoft.it
Application & technical support: suppor t@powersoft.it
Service & maintenance: service@powersoft.it
www.powersoft-audio.com
© 2012 - 2013 Powersoft powersoft_TN018_DigiModISKit_en_v1.0
Loading...