PORTACOOL
HAZARDOUS
LOCATION
OWNER’S
MANUAL
PACHZ260, PACHZ270
QUICK SETUP
1 |
Remove box and pallet |
2 |
Position evaporative cooler on level surface
3 4
This product needs to be hardwired into an appropriate electrical outlet by a certified electrician.
Fill reservoir or attach water hose |
|
Wire into an appropriate outlet |
5 For setup, Kuul ComfortTM with FirePro Technology™ evaporative media should appear wet before starting the fan. Check the water gauge to monitor water level in tank. The water adjustment valve on each portable evaporative cooler is set at max flow. However, ensure the knob is turned completely to the right before use.
Turn to the left to increase water flow. If entrainment occurs - water is spitting from the front of the product
- use the valve to decrease the water flow until entrainment ceases.
Fill the tank, then turn on the pump switch and the fan
6 Your Portacool portable evaporative cooler is meant to be used in an open-air environment, such as a warehouse or large shop. If you plan to use your
evaporative cooler in a more closed environment – such as a garage or small shop – you must provide adequate ambient airflow to ensure your evaporative cooler works at its highest efficiency. When using in a semiclosed environment, be sure to leave a door or window open to allow for the proper amount of airflow.
Ensure proper airflow is available
SAFETY
OPERATION WARNINGS
1.Not for use by children
2.Not for use by persons with reduced physical, sensory or mental capabilities
3.Not for use by persons who have not reviewed the owner’s manual and familiarized themselves with the operation of the product
SAFE OPERATION
To reduce the risk of electric shock, fire or injury:
•Read the evaporative cooler’s instructions, owner’s manual and labels before operating.
•Do not operate evaporative cooler unless all Kuul® evaporative media is securely in place.
•Operation near open flames or sparks is not recommended.
•Keep product away from flames or sparks.
•If operating near open flame or sparks, ensure the pump is continuously running in order to saturate and wet Kuul evaporative media.
•Never wash the evaporative cooler’s housing with a garden hose; water may harm the motor or electrical system.
•Do not operate any evaporative cooler with a damaged cord or plug.
•If the cord or plug become damaged in any way, entire cord should be replaced by a certified electrician, in accordance with these safety instructions.
•Any repairs to electrical components of Hazardous Location products must be performed by a licensed electrician certified to perform work in the location in which the product is being utilized or is otherwise in service. Any other maintenance or repairs to Hazardous Location products must be performed by qualified technicians who are trained in maintenance and repairs of equipment in the location in which the product is being utilized or is otherwise in service.
•Replacement of component parts with parts which are not authorized Portacool replacement parts may impair this product’s designation for use in Class I, Division 2, Groups C and D hazardous locations.
•Do not run cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings. Arrange cord away from traffic area so it will not be tripped over.
•Always unplug the electric cord to the evaporative cooler before performing inspections or repairs.
•Hardwire into outlet of appropriate current and voltage capacity.
•Do not step on or roll over power cord with heavy or sharp objects.
•Evaporative coolers should not be modified in any way other than repairs made by qualified individuals as defined herein with Portacool replacement parts.
•If the evaporative cooler is damaged or malfunctions, do not continue to operate it. Refer to the warranty, troubleshooting or FAQ sections of this Owner’s Manual, call Portacool, LLC Customer Service at 1-888-266-5243, or email support@portacool.com
OVERVIEW
PACHZ260
Controls
Water
Adjustment Valve
Power
Cord
Hose
Connection
Locking
Casters
This apparatus is suitable for use in Hazardous Locations designated as Class I, Division 2, Groups C and D.
OVERVIEW
PACHZ270
Controls
Water
Adjustment Valve
Power
Cord
Hose
Connection
Locking
Casters
This apparatus is suitable for use in Hazardous Locations designated as Class I, Division 2, Groups C and D.
Loading...