PL9000 – Power Pop
Universal Keyless Entry
System Tonneau Cover
Installation Instructions
1) Replace both of the existing rotary latches on the tonneau cover with the new supplied power adaptable rotaries. Install both Actuator Brackets with the supplied Bracket Bolts. Install both Linkage Rods by sliding them into the grooves in the rotary latch cable clamps, then hook the end of the linkage rods through the holes in the end of the Actuators and bolt the Actuators to the Actuator Brackets with the supplied Actuator Screws (there is a tab on the Actuator Bracket that only allows the Actuator to be mounted on one way). You may also need to install new strikes which are also supplied.
Actuator Bracket
Actuator
Power Adaptable Rotaries
2) Mount Keyless Receiver to tonneau cover centered between the rotary latches. Be sure to use proper length screws and only screw into the thick portions of the tonneau as to not protrude the outer surface of the tonneau cover.
3) Connect receiver actuator outputs to the actuators and bundle up and wire tie any excess wire length.
4) Connect Tonneau Harness to the Receiver. If using the optional in cab remote button, connect the gray wire from the Tonneau Harness to the gray wire on the Receiver. Route the Tonneau harness wire up the center of the tonneau cover then over to the driver side front corner of the box. Mount the harness with
supplied Cable Clamps and screws or under the carpeted head liner. Leave the end of the harness accessible to be able to later connect it to the Truck Harness.
POWERED BY:
5) Connect the optional 12 volt LED light (01355) to the timed light outputs on the Receiver, black to black and white to white. Mount light where desired.
6) Attach the Truck Harness to the Tonneau Harness with the one way plug in the front corner of the tonneau.
Route the Truck Harness down along the truck frame and up into the engine compartment. Fasten the Truck Harness securely with wire ties along the frame. Bundle and wire tie any extra wire from the Truck Harness securely up under the hood. Connect the red wire from the Truck Harness to any constant 12 volt power supply; most trucks have an auxiliary power terminal for such accessories. Be sure to properly ground the black wire.
7) If using the in cab remote button option, route the Button Harness into the cab of the truck through an existing grommet. Drill a ½” hole in the desired location of the button and mount it through the hole. Attach the black wire to a good ground and plug the gray wire from the Button Harness into the gray wire on the Truck Harness.
Loading...